Good news is, with speakers it doesn’t really matter which one you choose as your positive and which as your negative, just so long as you are consistent. Ultimately, what you want is for the wire that connects to the red terminal on your Amp or Receiver to connect to the red terminal on your speaker.
Thereof, How do you hook up a amp to a battery?
Connect the front, rear, and subwoofer speaker wires from the amplifier to the corresponding speakers. 5. Run the power lead from the amp (ensuring that it’s on the opposite side of the car to your RCA cables) through the hole in the firewall and to the battery.
Also to know is, Can you ground your amp to the battery? The best way to ground your car stereo components is to run a 10 or 12-gauge wire from the amp, and 12-gauge from all other components, such as head unit and active crossovers, to a central location. Then run a single ground to the best source of ground, the negative terminal on your car’s battery.
Subsequently, question is, Do you need to hook up the remote wire on your car amp? What wiring and accessories do I need? Car amplifiers don’t come with any wiring included. You must supply the amp’s power and ground wiring, an inline fuse, a remote turn-on wire, RCA cables, and speaker wires.
Also, How do you hook up two amps in a car?
How do you hook up a car stereo amplifier?
What can I ground my amp to?
So, where exactly should you ground your amplifier? The ground for the amplifier should be directed to a bare metal area of the car body, within eighteen inches of the amp’s location. Your objective is to try to ground to the main chassis or the sub frame.
What should the gain on my amp be set at?
Turn the stereo up to 2/3 the max volume. This is the best range to use when setting gain because you avoid overworking the stereo head. If you overwork the stereo head you could end up sending distorted sounds to your amplifier.
Where should I place my amp?
– On the floor hard against a wall.
– On the floor away from the wall.
– On a table.
– On a carpeted floor.
– On a tile floor.
– Angled 45 degrees pointing up (only recommend for small combo amps)
How long should an amp ground wire be?
The recommended way to ground your amplifiers is to keep your ground cable less than 18″ long, the same exact size/gauge as the power cable, bolted directly to a solid, thick steel part of the chassis which is scraped and polished clean of any paint or primer for best possible grounding.Dec 20, 1999
What gauge should a ground wire be?
16-gauge
How do you hook up two amplifiers?
Can I use the same ground for 2 amps?
As long as both amps are grounded to the same spot you should be able to avoid ground loop. Runing to a distro or running both grounds to the same spot ends up with the same result.
What should I set my low pass filter to?
As a general rule, the Low-Pass Filter should be set at a value approximately equal to (or below) 70% of your main speaker’s lowest frequency response. For example, your speaker’s frequency response goes down to 43Hz. 70% of 43Hz equals 30.1, so you should set the subwoofer’s low pass filter to 30Hz.
Can you connect two amplifiers together?
The short answer is that you can use any number or combination of power amps in a car audio setup as long as you wire them in properly. … The most common reason to wire in multiple amps is to have one for your main speakers and a second amplifier for a subwoofer.
How do I connect a second amplifier to my receiver?
Can you ground an amp to the battery?
The best way to ground your car stereo components is to run a 10 or 12-gauge wire from the amp, and 12-gauge from all other components, such as head unit and active crossovers, to a central location. Then run a single ground to the best source of ground, the negative terminal on your car’s battery.
Don’t forget to share this post 
References and Further Readings :