The amp load for testing should be recorded on the battery by the manufacturer. The load tester puts the battery under stress as if the boat were running and providing an amp reading. If you have a 500CCA battery, the load should test at 250 amps to indicate voltage with load. Reading should be over 11 Volts.
around 3-4 years
Thereof, Is there a difference between deep cycle and marine battery?
A deep cycle marine battery, or trolling battery, has several design differences. One key is plates: It has fewer, thicker plates allowing the battery to provide continuous power output over long time periods. Deep cycle batteries can be entirely drained and recharged many times over, cranking batteries can’t.
Also to know is, What should a fully charged boat battery read? The voltage on a fully charged battery should be about 12.7-12.8 volts. If it’s higher, the charger is on. Batteries will usually fail to start an engine at 12 volts or less.
Subsequently, question is, How do you know if your boat battery is bad? If your battery is reading 0 volts, chances are the battery experienced a short circuit. If the battery cannot reach higher than 10.5 volts when being charged, then the battery has a dead cell. If the battery is fully charged (according to the battery charger) but the voltage is 12.5 or less, the battery is sulfated.
Also, How do you test a deep cycle battery with a multimeter?
Place the prongs on the end of the colored wires from your load-tester onto the deep cycle battery terminals as you did using the multimeter, but put them on simultaneously and be prepared to start counting 15 seconds using a wrist watch or a stopwatch. Read the load-tester after 15 seconds.
How do you test a 12 volt deep cycle battery with a multimeter?
What is a good deep cycle marine battery?
– Best Overall: Odyssey Marine Dual Purpose Battery at Amazon. …
– Runner-Up, Best Overall: VMAX AGM Marine Battery at Amazon. …
– Best Budget (Dual Purpose): Bass Pro Shops Battery at Bass Pro Shops. …
– Best Budget (Trolling): Mighty Max Deep Cycle Battery at Amazon.
How do you test a marine battery to see if it is good?
Voltage Inspection Battery voltage after charge is an effective indication of battery health. Batteries with less than 100% voltage should be recharged before use. A 12-volt battery will read 12.6 volts or higher after charge; a 6-volt battery will read 6.4 volts or higher after charge.
Can you use a deep cycle marine battery in a car?
If the marine battery is a 12-volt battery, then you can use it for your car. This will enable it to be both a starter and a deep cycle battery. … Marine batteries are probably not recommended to power cars for a long period of time. This is because they would probably shorten the battery’s lifespan.
When should you use a deep cycle battery?
Deep cycle batteries are batteries that are designed for discharging and recharging such as in RV application, golf cart, floor scrubber, or electric vehicle. Deep cycle batteries as a rule should not be discharged below 80% depth of discharge.
What should a fully charged marine battery read?
Voltage on a fully charged battery will read 2.12 to 2.15 volts per cell, or 12.7 volts for a 12 volt battery. At 50% the reading will be 2.03 VPC (Volts Per Cell), and at 0% will be 1.75 VPC or less.
How do I use a multimeter to test a battery?
To test the battery, turn on your voltmeter, put the voltmeter on DCV and make sure that it is far above the battery voltage, on most voltmeters there is a setting “20” in the DCV area, so switch your voltmeter to that setting.
What is difference between deep cycle battery and regular?
Car batteries are specially designed to provide a short, sharp burst of power in order to crank over and start the vehicle’s engine. … Deep Cycle batteries are constructed using thicker battery plates and a denser active material, to withstand repeated charge and discharge cycles.
At what voltage is a 12 volt battery considered dead?
11 volts
How do I test a 12 volt battery with a multimeter?
Touch the black lead to the negative (-) terminal on the battery and the red lead to the positive (+) terminal. Note the reading on the meter. It tells you the voltage between the battery terminals. If the battery is good, the reading should actually be higher than 12 volts.
What should a 12 volt battery read when fully charged?
12.9 volts
Can you use a deep cycle battery for cranking?
A deep cycle battery is constructed differently than a cranking battery, with thicker, heavier plates. … Yes, a deep cycle battery can be used to start your motor in a pinch, but a two- or three-battery system is highly recommended to separate the engine battery from the accessory (house) batteries.
Don’t forget to share this post 
References and Further Readings :
