– Put your system into test mode (Enter your master code and type 5);
– Open the ADT keypad;
– Disconnect the white cable from the circuit board for 30 seconds;
– Connect the white cable back to the circuit board.
– Close the keypad;
– Enter your master code into the keypad;
When you get the ‘Check 103 Long Range Radio’ message on your Honeywell keypad it means that there is a problem with the cellualr communicator attached to your system. The trouble may be caused by a severe drop in signal strength.
Thereof, What does code 103 mean on ADT?
What is Check 103 on my ADT system? Check 103 is an error code that shows up on Honeywell ADT control panels if there is a problem with the cell or internet communication. Usually, it’s an issue with the cell radio.
Also to know is, What is long range radio ADT? The message “103 check lngrng radio” on your ADT System means that there is a problem with the system’s backup communicator.
Subsequently, question is, What does bF check mean on alarm system? backup failure
Also, What does check long range radio mean on ADT alarm?
The message “103 check lngrng radio” on your ADT System means that there is a problem with the system’s backup communicator. … The message can only appear on Alphanumeric Keypads. If you have a Fixed English Keypad for your ADT System, then you will see bF instead, which means “backup failure”.
Why does my ADT say cellular failure?
The Loss of RF Supervision signal indicates that one of your wireless devices is not correctly communicating to the main alarm panel. All wireless devices regularly communicate to the alarm panel to check that the signal is being correctly received.
How do I clear the fault on my ADT alarm?
The security system may need to be reset by entering your code into your system and hitting off twice. Remember to remove the system from Test Mode. Go to MyADT.com and click on My Alarm from the System Management option, select Stop Test to remove the system from test mode and restore operations.
How do I clear the fault on my Honeywell alarm?
Clear the keypad error by entering your four-digit security code and then pressing 1 (OFF key). If the screen shows a BAT error, which indicates a low system battery, this should clear when the battery recharges after 48 hours at the most.
What does trouble mean on ADT?
A trouble signal (sometimes indicated in the alarm history by the abbreviation TR) indicates a possible problem or difficulty with your security system, such as a loose wire, a poorly aligned sensor or a low battery status.
What does 6f mean on alarm system?
Long-Range Radio backup system
Where is the reset button on my ADT keypad?
– Press the “Status” button on the panel two times.
– Enter your user code and push “8.”
– Enter the user code and “1” to reset the panel.
What is comm failure on alarm?
This means that your alarm has tried to communicate with the monitoring station and did not succeed in connecting to it. It could be as simple as the phone line is dead to the alarm, or it tried to during a storm and the phone was not in service when it happened.
What does ADT code 103 mean?
check lngrng radio
How do I make my ADT alarm stop beeping?
Troubleshooting FAQs For many of our most popular systems, beeping alarms and low battery trouble beeps can be silenced by pressing the [OFF] or [#] buttons from the keypad. If this does not work, please refer to your system user’s manual for specific instructions.
How do I reset my ADT sensor?
The security system may need to be reset by entering your code into your system and hitting off twice. Remember to remove the system from Test Mode. Go to MyADT.com and click on My Alarm from the System Management option, select Stop Test to remove the system from test mode and restore operations.
What does FC mean for ADT alarm?
failed connection
What does OC mean on ADT alarm?
bad
Don’t forget to share this post 
References and Further Readings :
