Joist spacing of 24 inches is allowed for spans between 16 to 20 feet using 2-inch by 10-inch lumber of these three grades.
2 x 10 span =
20 span
Thereof, How far can a 2×6 joist span?
Also to know is, How far can a double 2×10 span without support? When supporting joists that span 12 feet with no overhang beyond the beam, a double ply beam can span in feet a value equal to its depth in inches. A double 2×12 beam can span 12 feet; a (2) 2×10 can span 10 feet and so on.
Subsequently, question is, What size should ceiling joists be? Though there is no standard joist size for the ceilings in all buildings, most average homes use ceiling joists in a board size of 2-by-6 inches. The range of joist sizes used in homes varies though, between 2-by-4 inches and 2-by-12 inches.
Also, How much weight can a double 2×10 hold?
1,200 lbs.
How far can a 2×6 span flat?
How much weight can a 2×10 hold flat?
1,200 lbs.
How far can a 2×6 span without support?
How far can a 2×6 Rafter span without support? The table states that 2 X 6 rafters spaced 16 inches on center (o.c) can span a maximum distance of 13 feet 5 inches. Another option are 2 X 8 rafters spaced 24 inches o.c.
How far can a triple 2×6 span without support?
A triple 2×6 beam over a span of 10′ feet should be more than sufficient for normal deck loads. Maximum span for a single 2×6 #2btr yellow pine is around 9′ feet. So YES you should be fine with triple 2×6..
How far can you span a 2×10?
In general terms, joists spaced 16 inches on center can span 1.5 times in feet their depth in inches. A 2×8 up to 12 feet; 2×10 to 15 feet and 2×12 to 18 feet.
What is the maximum span of a 2×6 ceiling joist?
For example, the highlighted cell (below) shows that a 2″ x 6″ Southern Yellow Pine joist, with a grade of #2, and spaced 24″ apart can have a maximum span of 10 feet – 0 inches (10-0), if you are designing your structure to support a plaster ceiling.
How far can a 6×6 span without support?
Each 6×6 beam only spans 12 feet, of which 2 of those feet are supported by a knee brace. So technically the beams only span 10ft.
How far can you cantilever a 2×10?
According to the new span tables and IRC provisions, cantilevers can extend up to one-fourth the backspan of the joist. This means that joists, such as southern pine 2x10s at 16 inches on-center, spanning 12 feet are allowed to cantilever up to an additional 3 feet (see illustration, below).
What size should a floor joist be?
Carl Hagstrom responds: The rule of thumb that I like to use when sizing uniformly loaded residential floor joists is “half the span plus two.” First, round the clear span of the floor joist up to the nearest foot, and divide by two.
How far can a 2×6 Rafter span without support?
How far can a 2×6 Rafter span without support? The table states that 2 X 6 rafters spaced 16 inches on center (o.c) can span a maximum distance of 13 feet 5 inches.
What is the maximum span for a 2×6 Rafter?
How far can a 2×10 span for a roof?
Don’t forget to share this post 
References and Further Readings :
