What is a Flammable Vapor (FV) Sensor? FV Sensors are safety devices on select models of water heaters, which cause a soft lockout (a.k.a. the unit shuts down) when flammable vapors are detected near the unit, to prevent the possibility of their ignition.
Thereof, How do you replace a flammable vapor sensor?
Also to know is, How do you reset a flammable vapor sensor?
Subsequently, question is, How do you fix flammable vapor lockout?
Also, How do you reset the vapor sensor on a Rheem water heater?
Turn the water heater’s gas valve switch to the “OFF” position, wait for a few seconds and then flip the switch to the “ON” position to reset the system. The water heater’s gas valve is located near the bottom of the unit and connects to your home’s natural gas line.
How do you test a flammable vapor sensor?
Flammable Vapor Sensor Location / Testing sensor from it’s bracket on the base ring of the water heater and disconnect both wires to the sensor. Take a resistance reading between the two wiring terminals of the FV sensor and note the resistance value.
How do you fix a flammable vapor sensor?
What is a vapor sensor?
The sensor is designed to detect the presence of a specific concentration of gasoline vapors. … The proprietary conductive polymer sensing film expands in the presence of flammable vapors significantly changing sensor resistance.
What does a flammable vapor sensor do?
What is a Flammable Vapor (FV) Sensor? FV Sensors are safety devices on select models of water heaters, which cause a soft lockout (a.k.a. the unit shuts down) when flammable vapors are detected near the unit, to prevent the possibility of their ignition.
How does a flammable vapor sensor work?
The sensor is required to detect flammable vapors in less than a minute after a spill enabling the gas valve control module to prevent the supply of gas and burner ignition. It is a passive device that requires no power and continually senses for vapors.
How do you bypass a Rheem vapor sensor?
How do you reset a vapor water heater?
How do you reset a state select gas water heater?
Locate the large red button marked “Reset” at the center of your State water heater’s control circuit panel. Firmly press the “Reset” button to manually reset your water heater. Once your water heater has been reset, it may take between 12 and 24 hours for your water heater to resume normal operation.
What does flammable vapor sensor lockout mean?
What is a Flammable Vapor (FV) Sensor? FV Sensors are safety devices on select models of water heaters, which cause a soft lockout (a.k.a. the unit shuts down) when flammable vapors are detected near the unit, to prevent the possibility of their ignition.
Where is the flammable vapor sensor located?
The FV sensor is located on front of many water heaters today. The sensor will trip if it senses gasoline vapors in the air. It does not respond to other types of flammable vapors.
How do you remove the flammable vapor sensor?
How do I reset my Honeywell flammable vapor sensor?
Don’t forget to share this post 
References and Further Readings :
