Thereof, What is a hip Val on a speed square?
Degree indicates the angle in degrees from 0° to 90°. Common indicates the rise in inches over a 12 inch run for common rafters from 1 inch to 30 inch. Hip/Val indicates the rise in inches over a 17 inch run for hip or valley rafters from 1 inch to 30 inch.
Also to know is, What angle do you cut rafters? Pitch Angle
—– —–
6/12 26.5
7/12 30.2
8/12 33.6
9/12 36.8
Subsequently, question is, How do you use a hip Val top cut?
Also, How do you read a speed square?
What is the diamond for on a Swanson Speed Square?
Squaring Lines The Swanson Speed Square has a diamond cutout along the ruler that allows you to square lines and make sure they’re perfect. That diamond cutout can be used to make a notch, or a birdsmouth, for rafter work.
What is the diamond for on a speed square?
Squaring Lines The Swanson Speed Square has a diamond cutout along the ruler that allows you to square lines and make sure they’re perfect. That diamond cutout can be used to make a notch, or a birdsmouth, for rafter work.
How do you cut a hip roof?
How do you pitch a roof with a speed square?
– Place the pivot point against the shingles.
– Then place a torpedo level on the fat base of the speed square.
– Adjust the square until the level is level.
– Read the pitch on the side of the speed square. Note: The pitch tells you the amount of vertical rise (in inches) for every 12 inches of run.
How do you cut common rafters?
How do you layout rafters?
How do you use a speed square a level?
What angle should the rafter tail be cut?
45° angle
How do you cut hip roof rafters?
How do you use a speed square to rafters?
How do you cut a rafter angle?
How do you cut rafters?
Don’t forget to share this post 
References and Further Readings :
