Hold the brake and turn the parking brake lever on. To start driving the lawn mower, you will need to disengage the brake. Then take the key and turn it in a clockwise motion to start the riding lawn mower. After the engine has started successfully, you can release the key.
Table of Contents
READ ALSO
Likewise, Why does my Craftsman mower won’t start?
Your Mower Won’t Start:
Other possible causes include: Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas.
Also, What spark plug do I need for my Craftsman mower?
Replacement Plug
The Craftsman 4.5hp mower uses either a Champion model RJ19LM or J19LM spark plug, or equivalent, with the gap set at .
Moreover, How do you start a Sears Craftsman lawn mower?
Starting
- Step 1: Place the key in the ignition switch.
- Step 2: Disengage the PTO by setting the lever to the PTO OFF position.
- Step 3: Set the parking brake.
- Step 4: Activate the choke.
- Step 5: Turn the key to START. …
- Step 6: Set the throttle/choke control to FAST before you start mowing.
Can a dirty air filter cause a lawn mower not to start?
Dirty or Clogged Air Filter
Before the incoming air enters the carburetor, it passes through an air filter to remove dust and dirt. When the filter is doing its job, it may get clogged up with debris removed from the air and not allow a sufficient amount of air into the carburetor and prevent the engine from starting.
How do you clean a lawn mower carburetor without removing it?
However, you can not spray the carburetor when the engine is off since it cannot do the cleaning without being propelled. All you need to do is to start the engine and spray directly at the center of the carburetor while it is running. Any deposits clogging in the carburetor will easily be removed.
Why does my lawn mower only run for a few seconds then dies?
If your lawn mower starts, runs briefly, then dies these are the four most common reasons that’s happening: Dirty carburetor / clogged carburetor bowl. Old gasoline that has gone bad. Dirty or defective spark plugs.
Do lawn mower spark plugs come pre gapped?
Lawnmower spark plugs can come pre-gapped, but this depends on the manufacturer. However, in most cases, the gap can be too small or too big, which can lead to ignition problems. … Spark plugs need to be pre-gapped to ensure proper ignition of the air and fuel mixture.
How often should you change the spark plug in a lawn mower?
When To Check & Replace Spark Plugs
For standard lawn mower and small engine maintenance, you should check and/or replace spark plugs: once a season. every 25 hours of use.
What kind of oil do I put in my Craftsman lawn mower?
SAE 10W-30 4-Cycle Lawn Mower Oil (20 oz.) – CMXG0AW1320 | CRAFTSMAN.
How much is a craftsman YT 3000 worth?
They’re selling new for $1799. Craftsman YT-3000 46 Inch Riding Mower With 19HP Briggs and Stratton Platinum Single Cylinder Engine Excellent for bigger backyards over one acre, and hard enough for industrial strength travel as well as lawn care.
How do you tell the year of a riding mower?
By locating the serial number tag on your machine, you can easily determine your mower’s age. If you have the owner’s manual for your mower, you can also check the date printed on the inside of the manual. This date should be one year after the mower’s manufacture date.
What year is a Craftsman DLT 3000?
The Craftsman DLT 3000 is one of the new tractor mower models for 2004.
What happens if you don’t change air filter on lawn mower?
Power Loss. A clogged air filter covered in oil and dirt will smother your engine, not allowing the proper amount of air to burn with the fuel. Less combustion power means less horsepower. If you notice your mower is not maintaining consistent power, check your air filter.
How often should you change fuel filter on lawn mower?
According to John Deere, a leading manufacturer of lawnmowers, homesteaders should change fuel filters after fifty hours of use. We translate that to mean changing filters at least once every other season of mowing.
Can a dirty air filter cause sputtering?
Sputtering and Stalling
A severely clogged air filter can cause the engine to sputter or even stall. When the engine is unable to draw in an adequate amount of air, it can experience an overly rich air-to-fuel ratio.
Can you clean a carburetor without removing it?
Cleaning a carburetor without removing it is fine. However, it can and should never replace the wholesome cleaning exercises. This is because it does not impact the entire length and breadth of the engine as should be the case.
Can I use wd40 to clean lawn mower carburetor?
WD-40 Specialist® Carb/Throttle Body & Parts Cleaner with attachable precision straw is the only all-in-one carburetor cleaner spray you will need to clean your carburetor, throttle body, and unpainted metal parts. … Then, the powerful cleaning spray blasts away the deposits and waste, leaving behind no residue.
What is the best carb cleaner for small engines?
9 Best Carburetor Cleaner For Small Engines
- Berryman Carb Cleaner. …
- Gumout Carb and Choke Cleaner. …
- CRC Choke and Carb Cleaner. …
- Gunk Chlorinated Carburetor Cleaner. …
- Berkebile Instant Gum Cutter Carburetor Cleaner. …
- Berryman Chemtool Carburetor Cleaner. …
- Gunk Non-Chlorinated Carburetor Cleaner. …
- Yamalube Carburetor Cleaner Dip.
Why does my lawnmower keep cutting off?
The loss of air flow to the engine caused by too tall or too thick grass or a dirty air filter is often the reason a mower engine stalls. … When you try to mow on overgrown lawn, you end up clogging the air filter and shutting off air to the engine.
Why does my lawnmower start but not stay running?
A full gas tank and oil reservoir are the essential first steps when checking why the lawn mower won’t stay running, but the problem could also be a dirty filter, clogged carburetor, improper fuel mixture, or a dirty spark plug. … However, you may need a lawn mower specialist to get you back to trimming your grass.
What is the difference between RC12YC and RC14YC spark plug?
The higher number is a slightly hotter spark type plug. The RC14YC4 is now the standard plug for the 990/992 Generac engines. The 999 in the new 16-22kW Evolution (7000 series) units and older 20kW units are still using the cooler RC12YC4 plugs. The ‘4’ at the end is the spark gap that’s preset at the Champion factory.
What happens if the spark plug gap is wrong?
If the spark plug gap is incorrectly set, it can lead to engine issues. The customer may experience loss of power, misfires, spark plug fouling, increased plug wear, or poor gas mileage.
What kind of spark plug does a Briggs and Stratton?
Flathead Engine Spark Plugs & Gaps
| Replacement Part Type | Briggs & Stratton Spark Plug Part Number | Spark Plug Gap |
|---|---|---|
| Extended Life Series® OHV Spark Plug Platinum (Replaces Champion RC12YC) | 696202 5066 (5066D, 5066H) | .030” |
| Resistor Spark plug – hotter spark (Replaces Champion RC14YC) | 496018S 5092 | .030” |
| Resistor | 692051 | .020” |
