Whether you have a gas or electric dryer, it has to plug into a wall outlet, and the breaker controlling the outlet may have tripped. If so, you can reset it by turning it all the way off, then on again. You can reset it by pressing the reset button on the front of the plug.
Thereof, How do you hook up a GE dryer power cord?
Also to know is, How do you hook up a GE dryer?
Subsequently, question is, Are dryer power cords universal? When replacing the existing dryer in your home, you can reuse its electric power supply cord if the old cord conforms to current safety codes and there is nothing wrong with the cord itself. … If you move to a new home, you may find that the outlet for your dryer does not match the dryer plug type on your appliance.
Also, Does a dryer have a reset button?
Many dryers are equipped with a reset button on the control panel. If the motor won’t run, let the dryer cool for about ten minutes. Then push the reset button. If there are no problems with the motor, switches, or electrical system, this should restart the dryer.
Why do dryers not have power cords?
Power cords are sold separately from dryers and ranges because the electrical codes and outlets for these specific appliances vary to a high degree. There is no standard like there is for washers and refrigerators. 
An electric dryer can use a 3-prong or 4-prong cord, while a gas dryer uses a 120 volt cord.
Why is my GE dryer not turning on?
Ensure that the START button has been depressed completely. Open the dryer door and inspect the condition of the door switch. If the door switch is scorched or pushed in, this may cause the dryer not to operate. Check to be sure that house circuit breakers / fuses are operational.
How do I fix the Start button on my GE dryer?
How do you hook up a GE dryer cord?
Do all tumble dryers have a reset button?
Not all tumble dryers have re-set buttons, so if it stops heating it is most likely to be because the thermostat or TOC (Thermal Overload Cutout) has tripped due to overheating.
How do you hook up a 3 prong dryer cord?
How do I know if my dryer fuse is blown?
– Unplug your dryer and ensure it is no longer connected to the gas or electric.
– Locate the thermal fuse, as above.
– Disconnect the thermal fuse from the wires.
– Test the fuse with a multimeter.
– If the needle on your multimeter does not move, your thermal fuse is blow.
How do I fix the Start button on my GE washer?
Does a GE dryer have a fuse?
In GE dryers, the thermal fuse–sometimes called a safety thermostat–is located behind the drum on the inside of the dryer. To access the thermal fuse you will need to open the dryer from the top.
Can a bad plug cause a dryer not to heat?
An electric dryer may run with a partial voltage of 110 volts, but it will not heat unless it has 208/240V, 30 amps. The circuit breaker could have partially tripped, even if it does not look as though it has. … The power cord may have a burned, broken, or loose connection at the back of the dryer.
Why is my GE dryer not working?
Open the dryer door and inspect the condition of the door switch. If the door switch is scorched or pushed in, this may cause the dryer not to operate. Check to be sure that house circuit breakers / fuses are operational. The dryer should be on a separate circuit.
Are all dryer power cords the same?
Almost all manufacturers sell dryers without a cord attached, allowing you to select 3-prong vs. 4-prong dryer cord to match your outlet. Be sure to check which type you will need before purchasing your appliance and power cord.
Don’t forget to share this post 
References and Further Readings :
