– Turn the power off at the breaker for 15 seconds and then flip it back on. This will reset the HL reading.
– You will notice the display show some numbers. This is just the software version. …
– If you see the HL come back within a day or so, this means that there is likely a problem with the probe or the motherboard.
If you have a Hot Tub FLO Error Code, this usually means there is an issue with water flow in your hot tub.
Thereof, How do I know if my hot tub has an airlock?
As mentioned above, the most common sign that your hot tub has an air lock is the jets not working when powered on. This can include nothing coming out of your jets when they are turned on or even a humming sound coming from the jets or pump.
Also to know is, Where is the bleeder valve on a hot tub pump?
Subsequently, question is, How do you test a hot tub pump? When your hot tub pump is dead… Check that your power is on, the breaker or GFCI test button are not tripped, all valves are in the open position. Follow the circ pump plumbing, and look for any kinks in the hose. Pull out the cartridge filter to see if flow improves and the circulation pump is doing better.
Also, How do you fix the code on a hot tub?
Check the water level to make sure it is not too low in the spa. Then make sure you do not have an air lock in the spa pump or spa heater causing the code. You can also try removing the spa filter, or replace with a new one to see if the error code goes away while the old filter is removed.
How do I know if my hot tub pump is bad?
– Humming noise from motor not turning, frozen shaft, bearings or impeller, or defective starting capacitor.
– Whining noise from worn bearings.
– Leaks under the pump from a failure of the pump seals.
How do I reset my hot tub control panel?
– Locate the spa’s high-limit reset. This is a red button found on many spa packs. …
– Press the high-limit reset button. …
– Turn on your spa and observe its operation. …
– Flip the breaker panel switch on or press the reset button on the GFCI outlet to restore power.
How do you test a spa pump?
How do I fix the code on my Arctic Spa?
Why is my hot tub not working?
The first step to take is to check the circuit breaker panel that your hot tub is hooked up to. … If this restores power to your tub temporarily before the breaker is tripped again, consult an electrician – the problem is likely with your breaker and not your spa. If this does not fix the problem, check the GFI switch.
How do you get rid of an airlock in a hot tub?
What does PR code mean on hot tub?
first actuated
What does Fl mean on a hot tub?
Pressure switch is not working
Is there a reset button on a hot tub?
There are generally two “hard resets” in hot tubs, the GFCI, and the high limit reset. The GFCI pops if there is any type of electrical short (such as water getting into the heating element, the reset on that can be in one of three places.
How do I unlock my Arctic Spa?
To unlock, press and hold pump 1 button for 5 second (LocF). Then press and hold for a further 5 seconds. Topside has been fully locked. To unlock, press and hold pump 1 button for 5 seconds.
What does Flo mean on Arctic Spa?
not reading enough water pressure
What causes air lock in hot tub?
They occur when the water level drops too low or after a water change, and air gets trapped in the lines or equipment. There are sensors in the hot tub that detect water flow or water line pressure to protect the hot tub heater from coming on when the water is not flowing past the heater element fast enough.
Don’t forget to share this post 
References and Further Readings :