Reset AquaRite Salt Chlorination Inspect Cell Light If the Inspect Cell Light is the only LED light flashing, then you can reset it by simply holding down the diagnostic button for 3 seconds, then release. The Inspect Cell indicator will now reset and will later come back on after another 500 hours of use.
– Verify that the salt level is between 2700 – 3400 ppm. 3200 ppm is the ideal salt level.
– Inspect and clean salt cell, if necessary.
– Check the cell voltage and amperage in both polarities. To switch polarities, toggle Main Switch from Auto to Off, and back to Auto.
Thereof, How do you fix a salt cell?
Mix one gallon of water with 1/4 gallon of muriatic acid in a large plastic container. Coil a few wires around the salt cell and slowly submerge it into the solution.
Also to know is, How long does salt last in a pool? 7 years
Subsequently, question is, How do I know if my Hayward Salt Cell is working? The easiest way to ascertain if the chlorinator is working is to make sure the cell is clean by checking the needle or production lights. Ensure there is enough salt in the pool. On the chlorinator box there should be a light or dial that indicates it is working.
Also, How do I know if my salt cell is bad?
If the salt cell bubbles, but only a little bit, then you probably have a bad cell. It is still a good idea to call a pool professional to confirm this diagnosis. If the salt cell bubbles vigorously, then it is working fine.
How do you test a salt cell?
What causes a salt cell to fail?
Salt cells fail for a few different reasons, the main reason being lack of proper maintenance. It is very important to check the cell regularly for excessive buildup. Doing this ensures excess calcium doesn’t become caked on the metallic plates. … Another common cause of salt cell failure is improper water balance.
Can a salt cell be repaired?
Salt Chlorine Generators do require some maintenance and repair. … Chances are, at some point you will face an expensive repair to your salt system, I’m talking about either a new salt cell, or a new control board. Both of these repairs can approach half the cost of a new system.
How do I know if I have enough salt in my pool?
You can purchase salt test strips for about $10 online or from any industry retailer. Test your water using a handheld digital test strip reader: Handheld digital test strip readers combine test strips with digital technology. Dip a test strip into your swimming pool and then insert it to the reader.
How often do Salt cells need to be replaced?
about five years
How do you test a pool salt cell?
How do I know if my salt cell needs replacing?
– Looking worse for wear, it’s lost a few plates and the acid baths just aren’t working.
– Your pool is starting to turn green or cloudy, even though your chlorinator is turned up to 100%.
How can I tell if my salt cell is bad?
– If the salt cell bubbles, but only a little bit, then you probably have a bad cell. …
– If the salt cell bubbles vigorously, then it is working fine.
– If the salt cell is good, but you are are constantly getting a zero chlorine reading in the pool, something else is wrong.
How long does a salt cell last?
about five years
How do you know when to replace your salt cell?
– Looking worse for wear, it’s lost a few plates and the acid baths just aren’t working.
– Your pool is starting to turn green or cloudy, even though your chlorinator is turned up to 100%.
How do you electrically test a salt chlorinator cell?
How do I check the salt level in my pool?
A pocket or pen style meter operates by turning the meter on, dip the meter tip into the pool and the salinity measurement is shown on the digital display. A little less portable meter lets you put a small sample of water into a reservoir cup, press the test button, and an analog needle swings to the salinity level.
Don’t forget to share this post 
References and Further Readings :
