How do I reset my Kenmore Elite ice maker?

Find the on and off switch on the front of the ice maker’s PC board and turn the machine off. Unplug the refrigerator and wait five minutes before plugging it back in. Turn the ice maker back on and return the cover plate.

Table of Contents

READ ALSO

How much does it cost to recoat a foam roof?

How much does it cost to replace a foam roof?

Can you bury liquid tight flexible conduit?

Thereof, Why is my ice maker not making ice Kenmore?

If the refrigerator ice maker is not working the water filter might be clogged. Try changing the water filter. … If the ice maker is not working the icemaker mold thermostat might be defective. Inside the control module of the ice maker is a thermostat which monitors the temperature of the ice mold (ice tray).

Also to know is, How do I get my Kenmore ice maker to work? – Check your refrigerator and make sure it’s perfectly level.
– Check your ice maker unit and make sure it’s level.
– Check the water supply line for damage, pinching, or kinks.
– Check the fill cup; make sure it’s aligned correctly with the water funnel.

Subsequently, question is, How do I reset my Kenmore side by side ice maker? The power to the ice maker module is provided through the receiver control board. If this control board experienced a power glitch or surge through the electrical lines, you may be able to reset it by completely unplugging the refrigerator to completely disconnect electrical power for 5 minutes.

Also, Why did my Kenmore refrigerator stop making ice?

Why is my Kenmore fridge not making ice?

Why is my ice maker not making much ice?

If your ice maker isn’t producing ice at all or is producing crescents or cubes that are smaller than usual, it’s typically indicative of a clog somewhere along the supply line. Cause: A common cause for a clog is frozen water in the line. Fix: To repair a frozen line, slide the refrigerator and unplug it.

How do you turn on a Kenmore ice maker?

Where is the icemaker on and off button on my Kenmore Elite refrigerator, model number 59675529400? According to page 17 of the owner’s manual to your refrigerator, you will need to raise the lever on the ice maker up to turn the unit off, or down to turn the ice maker on.

What causes a ice maker to stop working?

Cause: A common cause for a clog is frozen water in the line. … Cause: There is also a possibility that the water filter for the ice maker is clogged. Fix: Locate and replace the water filter. Filters for ice makers are typically located inside the refrigerator (to keep them from freezing).

How do I reset my Kenmore side by side refrigerator?

Press the Power Freezer and the Power Cool buttons at the same time. Hold the 2 buttons for 3 to 5 seconds. This will reset the refrigerator back to normal and the fridge will begin cooling again.

How do I get my ice maker to work?

Fix: Start by making sure all electrical connections are properly seated. Slide the refrigerator out from the wall, turn off the water supply valve and disconnect it from power. Locate the quick release plug on the back wall inside the freezer. Unplug the connection it and reconnect it to ensure it’s fully connected.

How do I turn on my ice maker?

– To turn on the icemaker, set the power switch to I (ON).
– When the icemaker is turned on, the green light will come on.
– To turn OFF the icemaker, set the power switch to O (OFF).

How do I know if my ice maker is working?

– If the icemaker mold is empty you can pour about 4 oz. of water in the icemaker mold.
– Wait about 2 hours.
– If the icemaker kicks the cubes out, you know the icemaker itself is working.