In order to check the transmission fluid on a ford explorer, you must remove the cap and dipstick located at the front of the engine bay, while the engine is running, and then reinsert and remove the dipstick to measure fluid level and viscosity.
To check transmission fluid in a 2003 ford explorer, use the check valve that is located on the bottom of the transmission of this vehicle. this will enable you to check the transmission fluid.
Thereof, How do you put transmission fluid in a 2007 Ford Explorer?
Also to know is, How do you put transmission fluid in a 2008 Ford Explorer?
Subsequently, question is, Where is the transmission stick located on a 2003 Ford Explorer? Where is the transmission dipstick located on a 2003 ford explorer? The transmission dipstick on a 2003 ford explored is located on the passenger side of the engine compartment.
Also, Where is the transmission dipstick located on a 2002 Ford Explorer?
Since this car does not have a dipstick, you have to use the check valve on the bottom of transmission of the car. On your 2002 ford explorer v6 there is no way to check the transmission fluid, these are sealed transmissions that do not have a dipstick.
How do you add fluid to a sealed transmission?
How do you fill a transmission on a 2002 Ford Explorer?
How do you fill the transmission on a 2007 Ford Explorer?
How do you fill a transmission on a 2003 Ford Explorer?
How do you fill up a new transmission with fluid?
To fill the new fluid, open the hood and pull out the automatic transmission fluid dipstick. Insert a funnel and pour the new transmission fluid through the funnel. Check your owner’s manual for the recommended type and quantity of transmission fluid. Pull the funnel out, reinstall the dipstick and close the hood.
Where is the transmission dipstick located on a 2003 Ford Explorer?
Where is the transmission dipstick located on a 2003 ford explorer? The transmission dipstick on a 2003 ford explored is located on the passenger side of the engine compartment.
How do you fill a transmission on a 2006 Ford Explorer?
What kind of transmission is in a 2003 Ford Explorer?
automatic transmission
How do you add transmission fluid without a dipstick?
If the vehicle does not have a dipstick, the transmission fluid must be checked at the transmission. This requires lifting the car on four jack stands; it must be level to check the fluid. There will be a fill plug on the side of the transmission case. This is not the drain plug located at the bottom of the sump.
How do you check the transmission fluid in a 2008 Ford Explorer?
– Start your truck.
– Get under the vehicle and remove the big bolt plug in the trans pan.
– If there is a small fluid stream coming out of your tranny hole, then it’s good to go.
– If there is No fluid coming out then you need to add fluid until you see that small.
Does a 2007 Ford Explorer have a transmission dipstick?
Find the transmission dipstick, which is usually brightly colored and toward the back of the engine. Remove the dipstick, being careful not to spill or drip any fluid. Wipe off the dipstick with a clean rag, just as you would do when checking the engine oil.
How do you check the transmission fluid on a Ford?
– Insert dipstick fully and pull out to check fluid level.
– Transmission fluid expands when warmed up (driving for 20-30 minutes) Transmission level should be between the “HOT” marks.
– If the vehicle is cold the level will be between the “COOL” marks.
Don’t forget to share this post 
References and Further Readings :