Thereof, Should my primer bulb stay hard?
Re: Is the primer bulb supposed to get soft?? It should only be hard (to squeeze) when fully primed before start, and should never be collapsed when running-that would indicate an obstruction upstream( clogged vent or filter or pickup , kinked hose, valve off, etc. )Apr 29, 2007
Also to know is, How does a primer ball work?
Subsequently, question is, How do you attach a primer bulb to a chainsaw?
Also, How does a primer bulb work?
Most weed trimmers have a primer bulb to prime the carburetor. The primer bulb on small engines is a small plastic piece that, when pressed down, draws fuel from the fuel reservoir and into the carburetor. The carburetor is a part of the engine that mixes fuel and air together to make a combustion.
Should there be gas in the primer bulb?
You should have fuel in the bulb when running. If you do not, the check valve in the primer is bad. It is essentially not seating and drawing air in through the discharge port. Then there is the other style that is a little more complex but works on the same principle as the Purge Primer.
Which fuel line goes to the primer bulb?
fuel intake line
Why is my primer bulb not working?
When the primer bulb isn’t working, it may be a problem with the bulb itself, with the fuel lines that feed fuel to the bulb or both. … The same goes for fuel lines. When they’ve hardened and cracked, they let in air, which makes it impossible to draw the fuel into the carburetor properly.
How do you take apart a primer bulb?
Is primer bulb necessary?
The primer bulb is downstream of the external RACOR fuel filter. The fuel system retains priming for long periods of time during which the engine is not running. Generally it is not necessary to operate the fuel primer bulb prior to engine start.
Should a primer bulb have gas in it?
the primer bulb should be mostly fuel, check the lines they get old and start cracking. replace with tygon. there is a fuel pump in the carb operated by pulses from the crank case, the diaphragm in it can can go bad also.
Does a fuel injected outboard need a primer bulb?
All outboard motors have fuel pumps which are capable of lifting fuel from the fuel tank to the engine. The purpose of the primer bulb is to prime the fuel lift pump with fuel. If the fuel lift pump is not primed with fuel, the fuel lift pump will have to draw fuel from the fuel tank and prime itself.
Why does my primer bulb collapse?
If you’ve got an in-line fuel filter, it could be clogged as well. You’re puling a vacuum somewhere on the furl tank side of your primer bulb. Either a vent problem or a blockage in the lines. Old lines can collapse as well.
How do I know if my primer bulb is working?
How do you put a primer bulb on a chainsaw?
– Let’s get started. REMOVING THE PRIMER BULB [top] 1. …
– Remove the top cover.
– Remove the starter assembly.
– Remove the air filter housing.
– Remove the carburetor.
– Remove the purge bulb.
– INSTALLING THE NEW PRIMER BULB [top] 7. …
– Install the purge bulb.
Why does my primer bulb not work?
When the primer bulb isn’t working, it may be a problem with the bulb itself, with the fuel lines that feed fuel to the bulb or both. … The same goes for fuel lines. When they’ve hardened and cracked, they let in air, which makes it impossible to draw the fuel into the carburetor properly.
How do you change the primer bulb on a Poulan Pro chainsaw?
– Let’s get started. …
– Remove the top cover.
– Remove the starter assembly.
– Remove the air filter housing.
– Remove the carburetor.
– Remove the purge bulb.
– INSTALLING THE NEW PRIMER BULB [top] 7. …
– Install the purge bulb.
Don’t forget to share this post 
References and Further Readings :