Hold the gas control button down while you hold the end of a lighted match or lighter at the end of the pilot tube. The pilot should start as soon as the flame is close enough. Hold the pilot button down for about 20 seconds to give the thermocouple time to heat up, then release it. The pilot should stay lit.
Thereof, How do you turn on heat Glo fireplace with remote?
Also to know is, How do you light the pilot on a Heat and Glo gas fireplace?
Subsequently, question is, How do I reset my heat and Glo remote?
Also, What happens if the pilot light goes out on a gas fireplace?
When the thermocouple senses a lit pilot, it leaves the main gas valve open. If the pilot light is out, or isn’t burning hot enough, it closes the valve, cutting off gas flow so it won’t build up inside your house.
How do you replace a thermocouple on a gas fireplace?
The only tool you need to replace a thermocouple is a wrench. Use it to unscrew the connector that holds the thermocouple to the gas valve, then unhook the probe from its clip and pull out the entire thermocouple assembly. Before you do this, be sure to turn off the line valve on the gas supply.
How do you turn on gas fireplace with remote?
Why won’t my pilot light light on my gas fireplace?
Check the main gas valve to make sure the gas is turned on. … If gas is coming out of the pilot, but it still won’t light, the spark igniter could be the problem. Alleyne says to look for and clear out any debris between the igniter and thermocouple.
How do you turn off a Heat and Glo fireplace?
Remember to shut the gas supply valve off (picture #1). If it remains lit, press the valve knob in slightly and rotate counter-clockwise until the word “ON” is in the 6 o’clock position. Finally, turn the unit’s ON/OFF switch (or wall switch or remote control) to the “ON” position to start your fire.
What do you do when your gas fireplace won’t light?
How do I turn on my heat and Glo gas fireplace?
How do you turn off child proof on a Heat and Glo fireplace?
The appliance can enter child proof mode when the fireplace is on or off. To exit child proof mode: Press the Up Arrow Button twice and Down Arrow Button once. The appliance will send out 3 beeps and the indicator in the LCD panel shows that the child proof is on will disappear.
How do you manually turn on a gas fireplace?
Turn the knob from the “Off” to the “Pilot” position. Push in the pilot knob, which manually sends gas into the system. Push the igniter button once every second until it lights. Depending on how long it’s been since the gas fireplace was last used, ignition may take multiple attempts.
Can I replace a thermocouple myself?
It’s easy to replace and a new one costs $5 to $10. Rather than trying to unfasten the thermocouple inside the water heater’s burning chamber, it’s easier to remove the whole burner and thermocouple assembly. … Then unfasten the three nuts that hold the thermocouple and the two gas tubes to the valve.
Why is my propane fireplace not working?
Step 1 – Check the main valve to make sure the gas is turned on. Step 2 – If the gas is on, and the pilot hasn’t been lit in several months, try purging the air out of the pilot tubing, To do this, hold the pilot button down for about two minutes while the air bleeds out.
How do you fix a gas fireplace remote?
How do I reset my electric fireplace remote?
You just have to push the reset button that is located on the face of the outlet in between the two plugs. If your electric fireplace is plugged into an outlet that is controlled by a wall switch, make sure the wall switch is flipped to the ON position.
Don’t forget to share this post 
References and Further Readings :
