– Use a hammer and a cold chisel to level the bottom of the hole and undercut its sides slightly so the patch can’t pop loose. …
– Brush on a concrete bonding liquid, …
– Mix the concrete with water and scoop some into the hole. …
– To burnish the surface very smooth, use a steel trowel (shown) on the final few passes.
Thereof, How do you fix a large hole in concrete?
Also to know is, How do you repair a damaged concrete floor?
Subsequently, question is, How do you patch a large hole? – Cut a piece of drywall into a square a little bit bigger than the hole.
– Hold the square over the hole in the drywall and trace around the edges.
– Cut along the lines on the wall with a drywall saw. …
– Inside the hole, attach a furring strip, a small, thin piece of wood, to either side of the hole with screws.
Also, How do you fix a big hole in drywall without a patch?
– Cut a piece of drywall into a square a little bit bigger than the hole.
– Hold the square over the hole in the drywall and trace around the edges.
– Cut along the lines on the wall with a drywall saw. …
– Inside the hole, attach a furring strip, a small, thin piece of wood, to either side of the hole with screws.
How do you patch a large hole in a concrete block wall?
How do you level a dip in concrete floor?
How do you fix a hole in a concrete block?
Mix together in a bucket one part Portland cement, three parts sand and enough water to make a stiff patching compound. Fill the hole with the patching compound. Use the corner of a trowel or your finger to pack the compound into the hole, making sure it is completely full.
What household items can I use to patch a large hole in the wall?
What household items can fix a hole in the wall? Squeeze a small amount of white toothpaste into the hole and smooth over the surface using a putty knife or index card. White bar soap can be used in a similar fashion. Dampen the bar of soap and rub it over the hole until it is filled.
Can you pour concrete over copper pipes?
The copper tube must be completely embedded in the concrete and adequate provision for thermal expansion should be provided where the tube enters/exits the concrete. … According to the Portland Cement Association the interaction of copper with both dry and wet concrete should not cause a corrosion concern.
How do you make a hole in concrete block?
How do I keep my concrete slab from sinking?
– Seal all open cracks and joints with a polyurethane or silicone caulk. …
– Make sure downspouts are discharging at least five feet away from any concrete slab – the farther the better.
How do you cover a big hole in the wall?
What is the easiest way to patch a hole in drywall?
How do you cover a large hole in the wall?
How do you fix a sinking concrete garage floor?
If your garage floor has a void underneath it, slabjacking is the best method for lifting the concrete back into position. Slabjacking means injecting a polyurethane foam through the concrete slab. As the fill is injected, it foams up and solidifies, raising the concrete as it does so.
How do you fix a hole in drywall the size of a fist?
Don’t forget to share this post 
References and Further Readings :
