If you are going to use 3-tabs for starter, you need to cut off the 3-tabs so the adhesive strip can be placed along edge of roof. Starter strips are essentially 3-tab shingles with the tabs cut off at the factory. They are more expensive because they have to take the time to cut off the tabs.
To begin installing the first shingles on your roof, cut off the three tabs on the shingle. Using a utility knife, cut them off at the bottom of the adhesive strip. This should leave you with about 1/2 of the shingle left.
Thereof, How do you Shingle a valley with 3 tabs?
Also to know is, Can I use 3 tab shingles for starter? A lot of roofers claim you don’t need to use officially designated starter strip shingles and instead opt for using repurposed 3-tab shingles as the starter strip. … Starter shingles should always overhang the eave and rake edges of the roof by about 1/4″-3/4″ to ensure adequate rain water drainage.
Subsequently, question is, How many bundles of shingles do I need calculator? The most accurate way to calculate how many bundles of shingles you’ll need is to get up on the roof and measure each roof plane. If all the roof planes are rectangles, you simply need to multiply the length times the width of each plane to get the square footage; then you will add up the square footage of each plane.
Also, How do you use nail starter strips for shingles?
How do you make a starter strip for shingles?
To begin installing the first shingles on your roof, cut off the three tabs on the shingle. Using a utility knife, cut them off at the bottom of the adhesive strip. This should leave you with about 1/2 of the shingle left.
What is the best way to shingle a valley?
How do you use starter strip shingles?
How many nails do you put in a 3 tab shingle?
4 nails
Do you need a starter course with architectural shingles?
You do need to use a starter course with architectural shingles. The starter edge will help seal the edges and cover your shingle joints. As it won’t be visible on the finished roof, you don’t need to worry about the look of your starter strip and whether it matches your architectural shingles.
Which side of the valley do you Shingle first?
Each end shingle strip should have the upper corner trimmed and set in a bead of roof cement. NRCA recommends shingles first be installed on the valley side with the lowest slope or shortest distance to the ridge. If all conditions are equal, either side may be installed first.
How many bundles of shingles do I need for 100 square feet?
three bundles
Where do starter shingles go?
Starter shingles go on under the first row of shingle. Since that row doesn’t have a shingle below it to protect the seams, the starter shingles act as that barrier. On the rake (gable) edges of the roof, starter has 2 functions: First, to provide a nice straight line to cut shingles on.
How many square feet are in a bundle of shingles?
33.3 sq. ft.
Is a starter strip necessary?
The starter strip is crucial because it adheres to the shingles on the edges of your roof and protects them from the elements. Without starter strip shingles, a gust of wind would have no trouble sneaking under the shingles on the edges of your roof and blowing them up, and perhaps even off, your roof.
Where do you put a starter strip for shingles?
Historically, starter strip shingles have been used not only at the lower eave edge of the roof, but experienced professionals also use them at the gable, or rake edges of roofs.
How do you do a valley with shingles?
Don’t forget to share this post 
References and Further Readings :