16 inches
Thereof, How do you frame a concrete basement wall?
Also to know is, What can I use for basement walls instead of drywall? – Wood Planks.
– Plastic Panels.
– Plywood.
– Veneer Plaster.
– Pegboard.
– Lath and Plaster.
– Wahoo Walls.
– Textured Wall Panels.
Subsequently, question is, What is the best way to frame a basement wall? There are two ways to frame a wall: you can either nail the top and bottom plates, then nail the studs in between, or build each section on the floor and then raise and nail it into place. If you’re building a wall in place, start by lining up the top and bottom plates and mark where the studs need to go.
Also, What is the cheapest way to finish a basement wall?
Paneling can be used as an inexpensive way to finish you basement walls or ceiling. Use a strong adhesive to put strips of wood on your concrete basement walls, and then use wood screws that match your paneling to attach the paneling to the wood strips.
How can I cover my basement walls cheaply?
Paneling. Paneling can be used as an inexpensive way to finish you basement walls or ceiling. Use a strong adhesive to put strips of wood on your concrete basement walls, and then use wood screws that match your paneling to attach the paneling to the wood strips.
Can you finish a basement for $10000?
Remodeling a basement costs $5,000 – $10,000 on average. This cost typically includes adding walls, flooring, electricity, and lighting so that the basement is ready to be inhabited. Adding finishing touches here and there could potentially cost much less.
What can be used in place of drywall?
– Wood Planks. Wood planks are an age-old drywall alternative that has certainly stood the test of time well. …
– Veneer Plaster. Veneer plaster might be the alternative that comes closest to traditional drywall. …
– Lath & Plaster. …
– Plywood and Sheet Wood. …
– Texture Wall Panels. …
– Brick & Masonry. …
– Exposed Concrete Block. …
– Cement Board.
Can you replace drywall with plywood?
Installing drywall over plywood Drywall can be installed over ½ inch plywood. This is done so that the plywood can act as a noise barrier, absorbing sound. Plywood is better for this than drywall, because it is not as dense.
How do you make concrete basement walls look good?
Paint Your Cinder Block Basement walls of cinder block, brick, or even poured concrete can be transformed pretty quickly and simply with a coat of paint. Go for a solid color, or get wild and design a mural to brighten up that subterranean space of yours.
What can I put on my basement concrete walls?
Basement Waterproofing Any gaps or cracks in your concrete floor and walls need to be sealed with cement. Special concrete coatings or a polyethylene membrane can also be applied as a barrier.
What can I use instead of drywall?
– Wood Planks. Wood planks are an age-old drywall alternative that has certainly stood the test of time well. …
– Veneer Plaster. Veneer plaster might be the alternative that comes closest to traditional drywall. …
– Lath & Plaster. …
– Plywood and Sheet Wood. …
– Texture Wall Panels. …
– Brick & Masonry. …
– Exposed Concrete Block. …
– Cement Board.
What did they use for walls before drywall?
Before drywall became widely used, building interiors were made of plaster. It has been around for millenniums. Ancient Egyptians burnt gypsums in open air fires to produce plaster.
What insulates better drywall or plywood?
Drywall offers superior fire resistance compared to plywood, making it the safer wall finish in most applications. … This makes it a useful insulating material for flooring, ceilings, roofing, and wall cladding. Insulation offered by plywood can greatly reduce heating and cooling costs.
How much does it cost to finish a 1500 sq ft basement?
The “Finishing System” Option Costs for having such a system installed are about $40 to $50 per square foot, which means that a 1,500 square foot basement could run you as much as $75,000 for a top-of-the-line system.
Is it OK to use plywood instead of drywall?
Plywood is a viable alternative to drywall for walls and ceilings. If you are planning on redoing your walls or ceilings, the typical materials you’ll use include Sheetrock or finished plywood. Each has its benefits as a building material and in some cases, finished plywood is the better alternative.
What were walls made of in the 1950?
Until the late-1950s, plaster walls were the norm in new home construction. These walls are sometimes called “horse-hair plaster” because it was common to mix horse hair into the wet plaster to add strength, and to prevent cracking with minor flexing.
Don’t forget to share this post 💖
References and Further Readings :
