90 days
Roll length 75 ft (22.9 m) 66.6 ft (20.2 m)
———– —————— ——————
Roll width 36 in (914 mm) 36 in (914 mm)
Roll size 225 ft2 (20.9 m2) 200 ft2 (18.6 m2)
Packaging Corrugated cartons Corrugated cartons
Roll weight 61.4 lbs (27.9 kg) 55 lbs (24.9 kg)
Thereof, Do you nail ice and water shield?
When nails penetrate the ice and water shield on the roof, the rubberized nature of the material creates a gasket effect on the shaft of the nail. Leaks simply don’t happen. Not only does ice and water shield stop leaks caused by ice dams, but it also stops leaks created by fierce wind-driven rain.
Also to know is, Does Ice and Water Shield go over felt? Felt over the ice and water, yes. … Ice and water shield is different from felt paper because it’s a rubberized membrane that sticks to itself and the wood roof sheathing. It creates a waterproof barrier to standing water if installed correctly. Felt paper does not stick to anything.
Subsequently, question is, How long is a roll of ice and water shield? Roll length 75 ft (22.9 m) 66.6 ft (20.2 m)
———– —————— ——————
Roll width 36 in (914 mm) 36 in (914 mm)
Roll size 225 ft2 (20.9 m2) 200 ft2 (18.6 m2)
Packaging Corrugated cartons Corrugated cartons
Roll weight 61.4 lbs (27.9 kg) 55 lbs (24.9 kg)
Also, How much does a roll of ice and water shield cost?
current product
————————————– ———————- ———————-
$7998 /roll $20500 /roll
(15) (230) (73)
Underlayment/Barrier Type Leak Barrier Synthetic Underlayment Synthetic Underlayment
Roofing Product Type Underlayment Underlayment Underlayment
Can you cut ice and water shield?
Grace Ice & Water Shield uses an extremely strong, cross-laminated, high density polyethylene carrier sheet that offers superior tear resistance, but is easy to cut and detail.
Do you overlap ice and water shield?
Follow with application of drip edge flashing and WaterGuard Rain & Ice as described above. A single length of WaterGuard Rain & Ice works best, but if that isn’t possible, successive overlaps should be 6″. Firmly hand-roll the laps to ensure a complete, water- tight bond.
What size rolls does ice and water shield come in?
GRACE ICE & WATER SHIELD® is supplied in 3 ft wide rolls of varying lengths. Membrane strips are also available in 75 ft (22.9 m) long rolls at widths of 6 in. (150 mm), 9 in. (225 mm), 12 in.
How long is a 2 square roll of ice and water shield?
Size
———————
Widths
Roll Lengths
Square Feet Per Rolls
How much does ice shield cost?
Does Ice and Water Shield go over the drip edge?
The best way is to install the roof drip edge only along the eaves first, then place ice-and-water barrier (in the snowbelt) or felt paper (underlayment) over the drip edge. This lets any water that gets on the roof run down the underlayment and over the drip edge.
What is the best ice and water shield?
“Grace Ice & Water Shield® has the best adhesion to the roof deck,” said one Wisconsin contractor who uses the roofing underlayment on job sites. “You will not have problems with ice damming, leaks, wind-driven rain… anything like that.”
Can you staple ice and water shield?
In regards to what Bergen said, it’s true. Less than 50 degrees and you need to staple your ice shield like felt. You can (and should, in my opinion) insist on installing ice & water shielding throughout your entire roof, especially if you know your home is prone to ice dam leaks. …
Does felt paper go over ice and water shield?
Felt paper does not stick to anything. … Drip Edge, Ice & Water shield and roofing paper. It is not absolutely necessary but it is extra protection over that area of the roof that could potentially have water backing up from roof edge ice dams, up and under the shingles.
Do you need ice and water shield on a shed?
As ice melts and the water freezes in a continual cycle, the water will creep up the roof and underneath the shingles. This is why it’s important to have Ice and Water Shield because it gives better protection barrier against ice.
How much do you overlap ice and water shield?
Do not extend the ice and water past the edge of the fascia board. Overlap the ice and water by at least 2 inches. Extend the ice and water to at least 2 ft into the warm space. Put felt over the ice and water and partially cover the fascia board.
Does Ice and Water Shield go under drip edge?
Although building code requires ice and water shield to overlap the drip edge, some drip edge manufacturers say the drip edge should be installed over the ice and water shield. This reversal allows for better protection in the case of an ice dam.
Don’t forget to share this post 
References and Further Readings :
