two to three years
Thereof, Why do I have to keep cleaning my flame sensor?
Could also be that your thermostat is no longer sensing the correct temperature and causing your furnace to remain on longer in the heating cycle than usual. This causes the burner to heat up the flame sensor and cause it to become dirty sooner than just a yearly maintenance.
Also to know is, How much does it cost to replace a furnace flame sensor? Depending on which furnace repair company you call, you can expect to pay anywhere from $350 to as much as $500 for a new flame sensor, plus the cost of the travel and diagnostic charge.
Subsequently, question is, How much does it cost to have someone look at your furnace? National Average $295
—————— ————
Typical Range $130 – $469
Low End – High End $60 – $1,010
Also, How long do flame sensors last?
two to three years
How often should a flame sensor be cleaned?
Generally speaking, the flame sensor should be replaced every two to three years as preventative maintenance.
How much does it cost to replace a flame sensor?
Depending on which furnace repair company you call, you can expect to pay anywhere from $350 to as much as $500 for a new flame sensor, plus the cost of the travel and diagnostic charge.
How much does it cost to clean a flame sensor?
Generally, the cost for cleaning the flame sensor is just the service call fee, so at Cates Heating and Cooling, you are looking to pay $98. For most customers, it is easier to get started on a service plan where a Cates technician will come out to inspect and perform maintenance on your furnace annually.
Whats the average cost to replace a furnace?
Installing or replacing a furnace costs $5,500 with a typical range between $2,612 and $6,311 including materials, equipment and labor. Replacing a gas furnace runs from $3,800 to $10,000 or more for high efficiency models in complex installations.
What makes a flame sensor go bad?
As with any piece of equipment a simple reason could be that dirty flame sensor just goes bad. However a more common reason is that it is just dirty. It is a sensitive sensor so any type of dust or carbon buildup could cause it to malfunction.
Can you bypass a flame sensor on a furnace?
Actually, you can bypass the flame sensor. the flame sensor is just a way of exposing the voltage on the flame sensor wire to the furnace burner flames. So you can connect the flame sensor wire to a screwdriver and put the screwdriver into the flames.
How long should a flame sensor last?
two to three years
How much does flame sensor cost?
Flame Sensors Depending on your furnace, this repair can cost between $180 and $250.
How do you test a flame sensor on a furnace?
What is the average cost of a gas furnace?
Average cost: $2,000 – $6,592 The average cost of a gas furnace installation ranges from $2,865 to $4,296. Gas furnace replacement costs will vary depending on the brand of furnace, energy efficiency AFUE rating, BTU – unit size, and the average labor cost rates in your area.
How much does it cost to replace gas furnace?
$2,150 – $5,900. The national average cost of a standard efficiency natural gas furnace ranges from $2,150 to $5,900 with most homeowners paying around $3,100. The price may vary based on brand, complexity of install, and the efficiency of the new unit. Get free estimates from furnace replacement pros near you.
What does a flame sensor do?
The flame sensor detects the presence of a flame. If the flame in the furnace goes out, the sensor can detect the change and send electrical signals to the furnace’s central controller.
Don’t forget to share this post 
References and Further Readings :