Other sources estimate the cost to install an asphalt driveway to be between $2,300 and $10,300. Homeowners typically pay per square foot. Reibling adds the average cost per square foot is between $3.50 and $4.50. Some asphalt contractors may charge by the ton, with the cost ranging from $100 to $150 per ton.
Thereof, How much does it cost to pave a 200 foot driveway?
Paving an asphalt driveway costs $4,719 on average, with a typical range between $2,930 and $6,559. This project runs $7 to $13 per square foot, including $2 to $6 per square foot for materials and $5 to $7 per square foot for labor.
Also to know is, Is 2 inches of asphalt enough for a driveway? For a regular driveway which is going to be used by regular cars, bicycles and bikes; 2 inches of asphalt is thick enough. Generally for resurfacing, 2 inches of asphalt is just about right, but if you are going for a stone surface and need a good base, it is better to layer up the asphalt thicker, around 3 inches.
Subsequently, question is, Can I patch my asphalt driveway? Steps for Asphalt and Concrete Driveway Repair Clean the cracks, using a strong spray from a garden hose. … Apply patching compound (for asphalt driveway repair) or concrete. Allow it to cure. Apply sealant.
Also, Does Salt ruin asphalt driveways?
Yes, rock salt can damage unsealed asphalt. Sodium chloride (Rock Salt) can accelerate the normal deterioration caused by freeze-thaw cycles in winter, shortening the lifespan of asphalt.
Are there different grades of asphalt for driveways?
There are three different grades available in asphalt. The grades available are I-2, also known as base; I-5, known as top ;and the I-4 or commercial top grades. The difference in the tree grades are that the I-2 or base consists of ¾ inches of stone. The base grade is generally used in corn stabilizing level.
How much does a blacktop driveway cost?
Paving an asphalt driveway costs $4,719 on average, with a typical range between $2,930 and $6,559. This project runs $7 to $13 per square foot, including $2 to $6 per square foot for materials and $5 to $7 per square foot for labor.
What is the cheapest type of driveway?
Gravel
How much is asphalt per sqft?
Ignoring any maintenance costs, asphalt is generally much cheaper to install than concrete. On average, the cost per square foot for asphalt will run between $2.50 to $4.00.
What is the cheapest way to do a driveway?
Gravel driveways are hands-down the most affordable option upfront. Asphalt driveways place second in cost, followed by cement and pavers. Although gravel driveways are the least expensive initially, they require the most maintenance long-term.
How do you blacktop a driveway?
– Clean your driveway with a high-powered hose. Ensure that all of the cracks are free of debris and plants. …
– Allow the asphalt dry thoroughly.
– Fill any cracks. …
– Fill any holes. …
– Allow the sealer to dry overnight.
– Clean the driveway. …
– Apply the sealer. …
– Block off the driveway, allowing it to dry for 24 hours.
What lasts longer asphalt or concrete?
Concrete driveways normally last longer than asphalt. In general, if installed properly in a suitable climate and maintained regularly, your concrete driveway should last 30 to 40 years, while an asphalt driveway is generally good for 20 to 30 years.
How long should an asphalt driveway last?
25-30 years
Is asphalt cheaper than concrete?
Cost. The cost of an asphalt driveway is typically cheaper than concrete, costing $2.00 – $4.00 per square foot. Asphalt prices tend to fluctuate with fluctuations in crude oil prices. In contrast, a concrete driveway costs between $4.00 – $6.00 per square foot for a standard installation.
Is blacktop cheaper than concrete?
The cost of an asphalt driveway is typically cheaper than concrete, costing $2.00 – $4.00 per square foot. Asphalt prices tend to fluctuate with fluctuations in crude oil prices. In contrast, a concrete driveway costs between $4.00 – $6.00 per square foot for a standard installation.
How much does it cost to put in a driveway?
The cost to put in a new driveway averages $4,425, with a typical range between $2,379 and $6,476. For most types, you can expect to pay $2 to $15 per square foot for materials and installation. Driveway prices depend mostly on the material, which ranges from $1 to $50 per square foot, and the dimensions of the area.
Is it cheaper to pave or concrete?
The cost of an asphalt driveway is typically cheaper than concrete, costing $2.00 – $4.00 per square foot. Asphalt prices tend to fluctuate with fluctuations in crude oil prices. In contrast, a concrete driveway costs between $4.00 – $6.00 per square foot for a standard installation.
Don’t forget to share this post 💖
References and Further Readings :