Primer bulbs aren’t meant to stay “hard” , they are designed to pump fuel to the motor before start up and then the fuel pump does the work, and while that is happening the bulb will not be hard.
Most common cause is a blocked air vent. Close third is a bad anti-siphon valve. A bad check valve in the primer bulb is a possibility also. To check for a vent blockage, run with the fuel filler cap off and see if the bulb collapses.
Thereof, Should there be gas in the primer bulb?
You should have fuel in the bulb when running. If you do not, the check valve in the primer is bad. It is essentially not seating and drawing air in through the discharge port. Then there is the other style that is a little more complex but works on the same principle as the Purge Primer.
Also to know is, Why does my outboard lose prime? Why Does My Outboard Lose Prime? Outboard engines lose fuel prime because of an air leak in the fuel system. Somewhere between the engine and the fuel tank.
Subsequently, question is, Why does my primer bulb not work? When the primer bulb isn’t working, it may be a problem with the bulb itself, with the fuel lines that feed fuel to the bulb or both. … The same goes for fuel lines. When they’ve hardened and cracked, they let in air, which makes it impossible to draw the fuel into the carburetor properly.
Also, How do you fix a broken primer bulb?
Is primer bulb necessary?
A primer bulb is important because it is helps to fill the carburetor with the correct amount of fuel. It does this by pulling fuel through the fuel line. You may need to fix or replace your primer bulb if: It is not creating proper suction.
How do you take apart a primer bulb?
How does a primer bulb work on a chainsaw?
Some chainsaws use a primer bulb to help suck gas into a cold carburetor. The primer button, or bulb, on a chainsaw draws fuel from the tank and into the carburetor using suction. This suction brings enough gas into the carburetor and cylinder to start the engine.
Why is my primer bulb not working?
When the primer bulb isn’t working, it may be a problem with the bulb itself, with the fuel lines that feed fuel to the bulb or both. … The same goes for fuel lines. When they’ve hardened and cracked, they let in air, which makes it impossible to draw the fuel into the carburetor properly.
How do you change a primer bulb?
Do primer bulbs need to be filled with gas?
the primer bulb should be mostly fuel, check the lines they get old and start cracking. replace with tygon. there is a fuel pump in the carb operated by pulses from the crank case, the diaphragm in it can can go bad also.
How do you prime a boat fuel line?
Why does my primer bulb collapse?
The priming bulb on your Weed Eater supplies fuel to the carburetor when the engine is cold. … That’s because the collapse, which may be due to the bulb itself, can also signify a blockage in the line leading to the bulb from the fuel tank. The cause is often related to gummy varnishes left by old fuel.
How do I know if my primer bulb is working?
Should a primer bulb have gas in it?
the primer bulb should be mostly fuel, check the lines they get old and start cracking. replace with tygon. there is a fuel pump in the carb operated by pulses from the crank case, the diaphragm in it can can go bad also.
How do you fix a primer bulb on a lawn mower?
How do you prime a lawn mower without a primer bulb?
Don’t forget to share this post 
References and Further Readings :
