automatic choke
An automatic choke closes against spring pressure. During engine crank, it then exposes almost full manifold vacuum to the carburetor venturi, drawing a large amount of fuel through the main metering system. … The choke plate and fast-idle cam are attached to the spring via the carburetor’s throttle linkage.
Thereof, How do you set an automatic choke?
When Setting An Automatic Choke the vehicle must be cold (hasn’t run for 4-5 hours): Remove the air cleaner assembly and depress the throttle twice. The first throttle press is to set the choke plate, and the second is to give the motor a shot of fuel. The choke blade should be completely closed at this point.
Also to know is, How does Honda auto choke work? When the engine starts up, the engine heat works to warm the wax cylinder to cause an expansion of the wax that pushes the piston out. This would force the choke control to move in the opposite direction for the choke plate to open; thus, more air would enter into the engine.
Subsequently, question is, What does auto choke mean on a lawn mower? The intelligent Auto Choke System automatically sets the choke to give optimum starting and running in all cutting conditions. … The customer no longer needs to think about operating the choke when (re)starting the engine. 2. There is no need to wait for the engine to warm up to start mowing.
Also, When should I use choke on my lawn mower?
Basically it makes a richer fuel-air mixture in order to keep the engine running while it warms up. You’ll have to turn the choke setting it lever off once the engine can sustain running on its own. Do any of you have battery-powered lawn mowers?
Is the choke supposed to be open or closed?
The choke is a plate in the carburetor that opens and closes to allow more or less air into the engine. When doing a cold start, the choke should be closed to limit the amount of air going in. This increases the amount of fuel in the cylinder and helps to keep the engine running, while it is trying to warm up.
How do you adjust the automatic choke on a Briggs and Stratton engine?
How does an automatic choke work?
An automatic choke closes against spring pressure. During engine crank, it then exposes almost full manifold vacuum to the carburetor venturi, drawing a large amount of fuel through the main metering system.
How do you fix an automatic choke on a lawn mower?
Do you have to run lawnmower with choke on?
Lawn Mower: Only Runs With The Choke On. … If your lawnmower will start and run with the choke on but dies when the choke is turned off, it may have a problem with the carburetor. The carburetor brings air and fuel together and mixes them in the perfect ratio for combustion before they enter the engine.
How does an auto choke work?
Most vehicles use an automatic choke. Typically, a thermostat in the choke will sense increasing engine heat that is being transmitted to the choke housing, and cause a bimetal spring to relax and open the choke valve.
How does an automatic choke work on a car?
The automatic choke found on most American collector cars is a simple flapper valve in the “throat” of the carburetor. When you close the flap, less air enters the engine. More gas goes in, which is what you want for cold starting. As the engine warms, the flap opens to let the engine breathe more air.
What happens if choke is left on?
Leaving the choke on for too long will cause unnecessary engine wear and waste fuel. … The engine needs its fuel to be vaporised in order to burn it. This is done by the carburettor where the fuel is mixed with clean air coming from the air filter, and sent into the pistons to be ignited.
How do you test auto choke?
How does auto choke work on Scooter?
How does an automatic choke work? Inside the automatic choke there is a small wax capsule with a heater coil wrapped around it. When the engine is started a voltage is applied to the heater and the wax heats up. As the wax begins to heat it expands and pushes the plunger out slowly.
Where is the choke on a Honda gcv160?
– Turn the fuel valve on the side of the engine 90 degrees counterclockwise to the “On” position.
– Move the choke throttle lever, located on the left of the fuel valve, to the “Choke” position if starting from cold. …
– Shift the flywheel brake control above the throttle/choke lever to the “Run” position.
How do I know if my electric choke is bad?
It should slowly open up and be fully opened within a couple of minutes. If it is not opening, the choke is either broken or not adjusted correctly. If it opens too fast then the choke needs to be adjusted. If it opens too slow, again — adjust.
Don’t forget to share this post 
References and Further Readings :
