Ignition Failure
Press the Mode button to place the heater in Standby Mode. Hold the Down Arrow and Mode buttons simultaneously for 3 seconds for Bypass operation. “bo” will be displayed on the screen. Measure the inlet Static Pressure (valve off) and Load Pressure (valve on / energized).
Thereof, How do I reset my Hayward pool heater?
The heater can be manually reset using the keypad by cycling the MODE button through “STANDBY” and back to the original operating mode (“POOL” or “SPA”).
Also to know is, How do you put a Raypak heater in remote mode?
Subsequently, question is, How do you light the pilot light on a Hayward pool heater?
Also, How do I reset my pool heater?
Reset the circuit breaker for the pool heater. Put the system in standby using the control panel (typically accomplished by pressing and holding the Up & Down buttons) Check for an error code (if you see a code like bD or HF this could indicate a gas problem and your system will not reset until the problem is resolved)
Where is the pilot light on Hayward pool heater?
What does def mean on pool heater?
defrosting
What does p5 mean on a pool heater?
That code is actually PS and it is stating that there is not enough pressure flowing through the heater to fire it up now if pressure from filter is good the pressure switch in heater is bad and you need to replace it, take a piece of wire and jump across the two terminals on the pressure switch then turn the heater on …
How do I turn on my Raypak heater?
How do I light the pilot on my pool heater?
Rotate the knob to the “PILOT” position and press and hold the knob down. This manually opens the pilot diaphragm and sends gas to the pilot assembly. While holding the knob down, press in the “click-lite” 3-4 times. This should ignite the pilot.
Do pool heaters have pilot lights?
Pilot Light Keeps Going Out This step of gas pool heater troubleshooting can be difficult if there is no pattern to the pilot light extinguishing. Ensure the pilot light isn’t being forced out by wind or water.
How do you clean a Hayward pool heater?
Turn off the burners and allow them to cool. Brush the burners with a wire brush to clean them. This is something that you should generally need to do only at the beginning of the pool season or once a year for annual maintenance.
How do you descale a pool heater?
Why is my pool heater not working?
The Heater Cycles on and Off This is usually caused by a water flow issue. This could be due to a dirty filter, a closed valve, or even reversed water connections. Sometimes, this can be caused by the thermostat itself, and you may need to replace it.
What does SF mean on Hayward pool heater?
Sensor Failure
How do I turn my pool heater on?
What does Flo mean on a pool heater?
Low or No Water Flow Detected
Don’t forget to share this post 💖
References and Further Readings :