Actually, you can bypass the flame sensor. the flame sensor is just a way of exposing the voltage on the flame sensor wire to the furnace burner flames. So you can connect the flame sensor wire to a screwdriver and put the screwdriver into the flames.
Thereof, How do you test a flame sensor?
Also to know is, How do you test a flame sensor with a multimeter?
Subsequently, question is, How does the flame sensor work? A furnace flame sensor works by detecting the presence of a flame within the furnace. … As the gas valve opens to begin the combustion process, the current is sent out from the sensor in order to detect the presence of heat from a flame.
Also, How do I know if my flame sensor is bad?
Signs Your Flame Sensor May be Failing Here are three tell-tale signs that your sensor may be going bad: Your gas burners light but go out almost immediately. There is visible soot, dust, or rust that covers the tip of the flame sensor itself. The porcelain area of the sensor unit is cracked, chipped, or broken.
Can a flame sensor be cleaned?
Cleaning the flame sensor You can use Emery cloth sandpaper or a fine abrasive pad to gently clean any build-up from the flame sensor’s sensing rod. If present, you should also clean off any corrosion where the power wire connects to the flame sensor terminal.
How much does it cost to clean a flame sensor?
Generally, the cost for cleaning the flame sensor is just the service call fee, so at Cates Heating and Cooling, you are looking to pay $98. For most customers, it is easier to get started on a service plan where a Cates technician will come out to inspect and perform maintenance on your furnace annually.
What is a good flame sensor reading?
When the flame lights you should read between . 5 and 10 microamps (μA) depending on the furnace. Readings between 2 and 6 are common.
How do you clean a flame sensor?
Once you have removed the sensor, gently rub the metal rod (and nothing else) with a very light grit sandpaper. Remember, you’re not sanding down an auto body here, just ridding the sensor of any buildup. Then, use a clean paper towel to wipe clean any dust left behind by the sanding.
How does a flame detector work?
Within 3-4 milliseconds, ultraviolet flame sensors can detect explosions and fires by measuring the levels of radiation in the atmosphere (additional radiation is emitted at the moment of ignition). … Other UV sources, such as lighting, arc welding and even sunlight can all trigger the sensor.
How much does flame sensor cost?
Similarly, flame sensors often become too dirty and malfunction, but these sensors can be fixed with a thorough cleaning. However, if it’s too far gone and you must replace the flame sensor, it will cost you anywhere from $80 – $250.
Can you jump out a flame sensor?
No…. you can’t jump out the flame sensor.
What causes a flame sensor to go bad?
As with any piece of equipment a simple reason could be that dirty flame sensor just goes bad. However a more common reason is that it is just dirty. It is a sensitive sensor so any type of dust or carbon buildup could cause it to malfunction.
How does a UV flame detector work?
UV detectors work by detecting the radiation emitted by a flame. They are capable of detecting explosions and fires within 4 milliseconds with a time delay of 3 to 4 seconds to minimize false alarms that can be triggered by other UV sources like sunlight, lightning, radiation and arc welding.
How long should a flame sensor last?
two to three years
Can IR sensor detect fire?
IR flame detectors can detect hydrocarbon or hydrogen flames. Hydrocarbon configurations suit facilities that process hydrocarbon gas or liquids — but are wholly unsuitable for detecting hydrogen flames or flames from other inorganic materials.
How do you test a flame detector?
– The portable flame sensor test unit should activate the flame detector at a distance of 3m within 20 seconds. – The detectors are fitted with internal IR LED’s that can be activated to optically test the detector. (The above tests apply to detectors at room temperature under normal factory lighting conditions.
Don’t forget to share this post 
References and Further Readings :
