The fuel tank cap has a small hole, which allows air to flow into the tank and create back-pressure to help deliver fuel to the carburetor. Dust or dirt can plug up this hole. As a result, the carburetor won’t get enough fuel, leading to surging. Surging can also occur due to water contaminating your fuel.
– Loosen the governor arm nut on the governor arm.
– Push the governor arm away from the carburetor, and open the carburetor throttle valve fully.
– Holding the carburetor throttle valve fully open, turn the governor arm shaft clockwise fully, and tighten the governor arm nut.
Thereof, What causes a carbureted engine to surge?
If an engine is not getting enough fuel (this is called “running lean”), due to fuel pressure (regulated by the fuel pump and regulator), restricted fuel injectors, a vacuum leak or really anything that throws off the fuel mixture going in to the engine, this can cause the surge.
Also to know is, How do you adjust the governor on a Honda lawn mower?
Subsequently, question is, How do you adjust the governor? To adjust the governor, you would loosen the screw on the bottom of the governor arm and push the governor arm so the throttle is wide open. Then you would turn the bottom “clip” (which is connected to the governor shaft) counter clockwise. This will set the governor shaft on top of the governor spool.
Also, How do you adjust the governor on a Briggs and Stratton twin?
How do I fix a small engine surging?
What causes a lawnmower engine to surge?
Problems in the Fuel System Check and clean the vent. Surging is also caused by water that got into the fuel. A mower left in a heavy rain or condensation on a hot summer day can choke the engine. Empty the gas tank, properly dispose of the old fuel and try a fresh batch of gasoline.
What position should the speed control be in when adjusting the governor?
Rotate governor lever clockwise so that throttle is in full wide open position. Throttle stop must contact cast stop on the carburetor. 5.
How do you fix a Briggs and Stratton surging?
How do you clean a carburetor on a Honda gcv160?
What position does the governor spring hold the throttle plate when the engine is not running?
What position should the speed control be in when adjusting the governor? Which ring provides a controlled film of oil to lubricate the compression ring? The governor spring is the only force on the throttle shaft when the engine is not running.
How do you adjust the speed on a Honda lawn mower?
What causes a small engine to rev up and down?
A lawnmower that hunts and surges may be experiencing something as simple as an airflow issue. If the air that the engine requires to run is blocked, especially sporadically, it can cause the engine to slow down. When the blockage moves or clears, the engine may suddenly rev up in response.
What causes small engines to surge?
Problems in the Fuel System Check and clean the vent. Surging is also caused by water that got into the fuel. A mower left in a heavy rain or condensation on a hot summer day can choke the engine. Empty the gas tank, properly dispose of the old fuel and try a fresh batch of gasoline.
How do you fix a surging engine?
Can bad spark plugs cause surging?
Surging and Lagging Another good indication that your spark plugs are dirty or worn is if your vehicle experiences surges of speed, resulting in a jerking acceleration. These surges occur because your spark plugs are not igniting the fuel in your engine at the proper rate, resulting in an uneven speed.
How do you adjust the governor on a lawn mower?
To adjust the governor, you would loosen the screw on the bottom of the governor arm and push the governor arm so the throttle is wide open. Then you would turn the bottom “clip” (which is connected to the governor shaft) counter clockwise. This will set the governor shaft on top of the governor spool.
Don’t forget to share this post 
References and Further Readings :
