Some anti-theft lights blink by default ( a small red light near the dash, for example is there to warn off thieves ). If this is some other type of light then disconnect your battery (negative first then positive) for 30 minutes and reconnect in reverse order (positive then negative). This should reset the computer.
Table of Contents
READ ALSO
Turn off the engine and remove the key from the ignition. Press the “Lock” button on the smart key to lock your system and reset the immobilizer anti-theft system.
Thereof, How much does it cost to reset anti theft system?
The Best in Auto Repair The average cost for antitheft system diagnosis & testing is between $44 and $56. Labor costs are estimated between $44 and $56. This range does not include taxes and fees, and does not factor in your unique location. Related repairs may also be needed.
Also to know is, How do you reset anti theft? Insert the key into the ignition and turn it to the on position, which activates your accessories but not the engine. Leave the key in position for about 10 – 15 minutes. Step 3: Check the anti-theft light again. If it’s no longer blinking, turn the key back to the Off position and allow it to set for a minute or two.
Subsequently, question is, What causes a Ford Focus not to start? While there are a variety of reasons your Ford Focus won’t start, the most common 3 are a dead battery, an alternator problem, or failed starter.
Also, How do I turn off anti theft on my Ford Focus?
Step 1: Insert the key into the door lock. Use the side door on the driver’s side and the physical key even if there is a keyless entry system on the car. Step 2: Turn the vehicle key to unlock the car door without releasing it. Hold the key for 30 seconds in the position.
How do I get my car out of anti theft mode?
Turn the key to unlock your car door, but don’t release it. Hold the key in this position for 20 to 30 seconds. This lets the system know you have the correct key, and it can allow you to bypass the alarm system. Some vehicles recognize the key simply by turning the key back and forth in the door lock key cylinder.
How do I get my car out of anti theft mode without remote?
– Check your owner’s manual. Every vehicle is different. …
– Lock your doors. Getting into the car and locking your doors (assuming you have electric locks) might stop the alarm.
– Turn the car on. …
– Turn the ignition to on and wait. …
– Pull the fuse for the alarm. …
– Pull the wires for your alarm. …
– Disconnect the battery.
What triggers theft deterrent system?
The theft-deterrent system in your vehicle may be triggered by the following: Key learning (copy of key made) Forced entry alarm (door, trunk, hood) … Charging alarm (electric vehicles only)
What does it mean if my car turns over but wont start?
When your engine cranks but won’t start or run, it could mean your engine is having trouble producing a spark, getting fuel, or creating compression. The most common causes are problems in the ignition (for example, a bad ignition coil) or fuel system (for example, a clogged fuel filter).
How do I turn off Ford anti theft system?
You can turn off Ford anti theft by following these steps: First step is removing positive cable from battery in order to place key in automobile safely. Second step is to turn the “on” position then replace the positive cable. Last step, drivers need to turn the key off and on in order to reset the anti theft system.
How do I turn off anti theft without key fob?
– Check your owner’s manual. Every vehicle is different. …
– Lock your doors. Getting into the car and locking your doors (assuming you have electric locks) might stop the alarm.
– Turn the car on. …
– Turn the ignition to on and wait. …
– Pull the fuse for the alarm. …
– Pull the wires for your alarm. …
– Disconnect the battery.
What sensors will cause a car not to start?
A bad Crankshaft Position sensor is a common cause of no starts. The signal from this sensor goes to the PCM or ignition module that switches the ignition coil(s) on and off. If you have an RPM signal, a bad ignition module or PCM may not be switching the coil(s) on and off.
How do you override anti theft system?
Hold the key for 30 seconds in the position. That will tell the system you have the right key, and it will enable you to be able to bypass the car’s alarm system. There are some cars that will recognize the key by just turning back and forth on the key inside of the door’s lock key cylinder.
How do I reset my Ford anti theft?
– Insert your first programmed key into the car’s ignition and turn it to the “On” position.
– Cycle the first key back “Off,” remove it from the ignition and insert the second programmed key within 5 seconds.
– Cycle in “On” and “Off” and then remove the second key.
How do I reset my Ford security system?
– Examine the remote entry key and find the loudspeaker icon. Press this icon to turn on the personal alarm. …
– Press the loudspeaker icon one more time or put the key into the ignition and turn it to the “On” position to reset the alarm. Turn off the Securilock feature by turning the ignition key to the “Off” position.
Can you disable passlock?
The Passlock system on a Vehicles is the anti-theft system. The Passlock system uses a recognition transponder in the ignition tumbler and a computer chip in the ignition key. … While you cannot remove the Passlock system, you can disable it by tricking it into thinking the Vehicles had a malfunction.
How do I reset theft deterrent?
All you need for this is your ignition key. Turn the key to the unlock position. Turn the key to the lock position. Turn the key back to the unlock position. The alarm should now be disabled.
Don’t forget to share this post 💖
References and Further Readings :
