If your concrete saw is hard to start, check the following parts: air filter, starter, filter, carburetor, muffler, spark plug, and gasket. Also, ensure you are using fresh fuel and that it is mixed to the proper ratio with your oil for your two-stroke engine. … Bad fuel can cause a hard start situation.
Thereof, Where is the serial number on Stihl TS 420?
Similarly, where is the serial number on Stihl TS 420? The model and serial number on Stihl Demo Saws can be found in a few locations which include: the model number will be on the recoil housing, the serial number on the underside of the filter cover, it will also be stamped on a metal tag under the crankcase housing.
Also to know is, How do you start a Stihl saw?
Subsequently, question is, How do you start a Husqvarna cut saw?
Also, How do you start a Husqvarna concrete saw?
Are Stihl chainsaws hard to start?
Regular maintenance will help to ensure that your Stihl chain saw will always start. In addition, some storage steps can help with starting when the chainsaw has been left for an extended period. Problems starting a Stihl chain saw can be related to gasoline storage, spark plugs, and incorrect starting procedures.
How do you start a chainsaw that won’t start?
To solve this problem, open the spark plug hole with it facing away from you to drain all the fuel in the tank. Deactivate the choke by pushing in the control then pull the starter cord 6-8 times as you press in the throttle control. Dry off the spark plug and refit it back in place.
How do you start a Stihl ts420 concrete saw?
Can you use starting fluid to start a chainsaw?
Removing the air filter, spraying starting fluid into the carburetor and pulling the starting rope is another quick way to clear out the engine. Starting fluid creates a leaner fuel mixture that ignites more easily, and the operation of the engine clears out the combustion chamber automatically.
What size blade fits a Stihl ts400?
14″
How do you turn on a concrete saw?
How do I start my Stihl chainsaw for the first time?
Press and hold the throttle trigger lockout (located on the side of the chainsaw, above the trigger) with your thumb, then move the master control (on the left of the rear of the chainsaw) down as far as it will go. This is the position you should start the chainsaw in the first time you use it each session.
How do I start a partner saw?
How do you start a flooded concrete saw?
How do you change the blade on a Stihl ts400?
How do you start a Stihl ms251c?
How do I find my Stihl serial number?
Where do I find my serial number? Most serial numbers are stamped in the motor housing or crankcase to the left or right of the muffler looking down from the top on a flat surface. They will in most cases be 9 digits long and begin with the number 1, 2 or 5.
Don’t forget to share this post 
References and Further Readings :
