– Drill through the wall with the installer bit.
– Remove the bit from the drill (leaving it in the hole).
– Go outside and (or have a helper) connect the cable to the end of the installer bit.
– Back inside, pull the bit and cable back through the hole.
In other words, if you drill a hole for wire through the middle of a 3 1/2″ stud, you should try and stay in the middle 1″ area. If you go closer to the edges, you need to protect the area with a metal plate.
Thereof, What happens if you drill into a wire?
Damage to electrical wiring from drilling into walls is a surprisingly frequent phenomenon – especially when buildings are being renovated. In the worst case, if the protective earth conductor has been damaged you otherwise run the risk of a fatal electric shock.
Also to know is, Can you drill into the corner of a wall? Subject: Can I attach (screw) something into a drywall corner bead? Yes…for best results drill a pilot hole with a bit designed for metal and then use a longer screw so that it bites into the stud. The corner is actually a great place to attach things.
Subsequently, question is, How do you drill an outside wall for cable? Drilling the hole Drill through the wall with the installer bit. Remove the bit from the drill (leaving it in the hole). Go outside and (or have a helper) connect the cable to the end of the installer bit. Back inside, pull the bit and cable back through the hole.
Also, Can I screw directly into wall?
Simple Answer: NO – A screw directly into drywall will not hold. You need to use some type of picture hanging hardware to hang a heavy picture securely. The threads of a screw into only drywall, without an anchor, will NOT permanently hold in the drywall.
Is it safe to drill above an outlet?
The vertical wires are typically pretty easy to avoid: avoid drilling above a receptacle or light switch. The horizontal runs should have enough space to avoid most damage, unless you drill into the hole in the stud that they pass through.
How do I drill a hole in the wall?
Can you just drill into a wall?
If your wall is smooth and sounds hollow when you knock on it, it’s likely a form of drywall, such as sheetrock or plasterboard. For drilling a simple hole into this type of wall, a drywall bit is your best bet. You can purchase drywall bits and other types of drill bits at most hardware or home improvement stores.
How do you put a screw in the wall?
How do you drill a cable through a wall?
– Drill through the wall with the installer bit.
– Remove the bit from the drill (leaving it in the hole).
– Go outside and (or have a helper) connect the cable to the end of the installer bit.
– Back inside, pull the bit and cable back through the hole.
How do I make sure I don’t drill into a wire?
How do you drill a hole in the side of a house?
Is it safe to cover an electrical outlet?
Don’t: Leave Outlets Uncovered All wall outlets should have plastic covers to prevent debris from interfering with the sockets. Covering your outlets will also prevent pets and small children from accidentally shocking themselves. Even if an outlet isn’t working, you should still make sure it’s covered.
How do you put a screw in the wall with a drill?
How do you fish cable through an outside wall?
You can push the wire leader with the cable attached toward the Sheetrock (or the side with the opening). Hold the paddle magnet against the wall and move it around a little until it latches onto the leader magnet. Then, using short pulling motions, pull the leader magnet right through the insulation to the opening.
How do you cut a hole in a wall?
How do you run cable through a wall?
Don’t forget to share this post 
References and Further Readings :
