When sheathing a roof, the first step is to snap a line so that the first row goes on straight. But if you snap it at 40 inches, then the sheathing will not project over the subfascia or true fascia. This opens the door to the possibility of water damage by letting gravity work against you. Don’t do that.
Thereof, How far should shingles overhang the roof?
Shingles should not extend more than 3/4” (19 mm) past the drip edge. If shingles overhang the edge of the roof by more than 3/4” (19 mm), then they are not supported and may crack and break off. In addition, the wind resistance at the roof edge may be compromised.
Also to know is, How much does it cost to install sheathing? Labor costs differ, depending on the company that the homeowner chooses for the project. On average, however, most contractors charge around $100 to $150 per 100 square feet of plywood siding installed. Some companies charge by the hour.
Subsequently, question is, How far should sheathing overhang fascia? The overhang is multiple meaning that the sheeting you would overhang some 3/4-1″ followed by a drip edge then if using shingles another 1″. If using metal w/o drip another 3/4-1″ past the wood sheeting. You would want to keep your completed overhang close to 1-1/2″ if using gutter.
Also, How much does it cost to install OSB?
Installing either sheathing over a 500 square foot area would cost roughly $160 in material for plywood and $100 for OSB. Installation costs for both would be $490, assuming that the carpenter can install approximately 75 feet of material per hour.
How do you fix overhang shingles?
How do you calculate sheathing?
Divide the total roof area by 32 to get the number of sheets you will need to cover the roof. A typical 4 foot by 8 foot sheet of plywood covers 32 square feet. If your roof area is 1,600 square feet, 1,600 divided by 32 will mean you need about 50 sheets to cover the roof.
How much does it cost to replace a roof on a 1500 square foot house?
Cost of replacing the roofing on a 1500 square foot house ft—equates to $1,800 to $6,000 for a 1500 sq. ft house.
How long can roof sheathing be exposed?
Housewrap varies, but I’ve seen it left exposed for six months or more without appreciable damage. Some Tyvek products can be left exposed for up to 9 months. Once the frame is up, sheathed and wrapped with a breathable wrap, moisture can get out through the wrap without causing any damage.
Is OSB more expensive than plywood?
A simple trip to the average lumberyard or home supply store is all it takes to realize that OSB is almost always cheaper than plywood. … “For a typical 2,400 square foot home, OSB will save about $700 if used as the subfloor, sheathing, and roof decking instead of plywood.”
How much does it cost to sheath a house?
For low-end plywood siding, homeowners can expect to pay at least $2.40 per square foot. This comes out to be around $3,000 to cover 1,250 square feet. High-end plywood siding costs around $4 per square foot, which equals about $5,000 to cover the same 1,250-square-foot area.
What is the price of OSB plywood?
in Inches in MM (rounded) Price per Sheet
——— ————— —————
1/4″ 6 $15 – $20
7/16″ 11 $20 – $25
1/2″ 13 $21 – $28
23/32″ 18 $26 – $32
Do you have to stagger roof sheathing?
Plywood panels should be laid with the face grain perpendicular to the rafter boards. Staggering panels by at least two supports is recommended. OSB sheathing panels comply with the following industry standards and certifications. …
How do you fix lifted shingles?
– Slip a flat pry bar under the damaged shingle and press down to pop out the roofing nails.
– Slide the new shingle up into place. Be sure to align with the shingles of either side.
– Carefully lift the upper shingle and secure the new shingle with roofing nails.
Should I use OSB or plywood on my roof?
Plywood Holds the Moisture Advantage Over OSB When plywood gets wet, it tends to swell. … OSB takes longer than plywood to get saturated, but also takes much longer to dry out. When used as roof sheathing, this tendency to hold moisture means it will degrade faster than plywood when exposed to chronic leaks.
Is plywood cheaper than OSB?
A simple trip to the average lumberyard or home supply store is all it takes to realize that OSB is almost always cheaper than plywood. … “For a typical 2,400 square foot home, OSB will save about $700 if used as the subfloor, sheathing, and roof decking instead of plywood.”
How much does it cost to replace a roof on a 2000 square foot house?
House (& Roof**) by Square Foot Re-Roofing Cost*
——————————- —————-
1,800 (1,897) $6,700 – $9,500
1,900 (2,003) $7,000 – $10,000
2,000 (2,108) $7,400 – $10,500
2,500 (2,635) $9,000 – $13,000
Don’t forget to share this post 
References and Further Readings :
