Your mower may have a bad coil, especially if you cannot re-start your mower while it is still hot. If you have to wait for the mower to cool to start it, you should probably replace the ignition coil.
Thereof, How do you set the points on a Briggs and Stratton engine?
Also to know is, How do you set a point gap?
Subsequently, question is, How do you check a chainsaw coil with a multimeter?
Also, Do Briggs and Stratton engines have points?
Since 1982, Briggs & Stratton engines have used a solid-state ignition. Models built before 1982 employed a magneto, points and condenser system to generate spark for the spark plug. If you are using an older model Briggs & Stratton engine that has no spark, you might need to set the points.
What happens if point gap is too small?
When the points open, the light will come on. … Also, having too small of a point gap increases point “dwell” and can cause the points and coils to overheat. Too wide of a point gap can lead to a weak spark. The procedure, in a nutshell, is you set point gaps between 0.014″ and 0.16″.
How do you clean the points on a Briggs and Stratton engine?
How do you set a point gap on a lawn mower?
How do you clean ignition points?
How do you replace points?
How do you test a coil?
Connect your multimeter to the positive terminal or pin of your coil, and to the high output terminal that goes to the spark plug. Most ignition coils should have a secondary resistance falling somewhere between 6,000 to 10,000 ohms;however, refer to manufacturer specifications for the correct range.
How does point gap affect timing?
A wider gap will advance the timing. The sooner they open the wider the gap will be. As you increase the gap, the dwell angle will decrease because the points will open earlier. The spark occurs when the points open, hence increased spark timing.
HOW DO points work?
Mortgage points, also known as discount points, are fees paid directly to the lender at closing in exchange for a reduced interest rate. This is also called “buying down the rate,” which can lower your monthly mortgage payments. One point costs 1 percent of your mortgage amount (or $1,000 for every $100,000).
How do you set ignition points?
Contact breaker with points fully open. The gap shown is exaggerated for clarity. Place the feeler gauge blade between the points, and a screwdriver blade in the adjusting slots. Tighten the fixing screw, then check that points gap remains the same.
How do you check ignition points?
Test for continuity between the block and the stationary point attached to the distributor plate. Rotate the engine until the points are closed. Use the multi-meter to test for a good connection between the points. A slight gap when the points are supposed to be closed will keep your machine from running.
What happens if spark plug gap is too small?
The Spark-Plug Gap If the gap is too small, the spark will likely be too weak and cause the engine to run poorly or with poor efficiency. … A spark-plug gap gauge both measures and adjusts the gap and is inexpensive and simple to use.
How do you test a chainsaw coil?
Pull the start rope on the chainsaw and watch the end of the plug as you do. If you observe a spark jumping between the tips of the spark plug gap, it means the chainsaw coil is good. If there is no spark, it means the chainsaw coil will need to be replaced.
Don’t forget to share this post 
References and Further Readings :