Check the Drive Belt When the belt becomes worn or damaged, blades will not engage. Correct the problem by replacing the drive belt. Also, if the drive belt is not routed properly when installed, the blades will not engage. Refer to the diagram in your owner’s manual to ensure the belt is installed properly.
Thereof, How do I know if my PTO clutch is bad?
Activate the PTO engagement lever, then disengage it. Turn it on and off several times. If you do not hear a disengagement noise or see the power takeoff pulley stopping or slowing down at any time, it indicates the clutch and plates have galled together from excessive heat, or the slip ring has jammed.
Also to know is, Why wont my mower deck engage? If your mower blades will not turn after the blade controls have been engaged, your deck belt may be broken. The deck is located directly under the operators seat. This belt spins the mowers blades and runs through a pulley system of idlers. The exact configuration of the deck belt will depend on your model of mower.
Subsequently, question is, Why won’t my mower blades engage? Check the Drive Belt When the belt becomes worn or damaged, blades will not engage. Correct the problem by replacing the drive belt. Also, if the drive belt is not routed properly when installed, the blades will not engage. Refer to the diagram in your owner’s manual to ensure the belt is installed properly.
Also, What is a PTO switch on a lawn mower?
The PTO is a switch or lever found on tractors and mowers and stands for Power Take Off. This can be an electric switch or mechanical engagement that takes engine power to operate the mower deck or an implement. The PTO can run mowers by either a belt or a shaft.
How does an electric PTO clutch work?
The electric clutch helps to transfer engine power to the drive train. … PTO clutches work in conjunction with the PTO drive shaft and must be compatible with the transmission of the lawnmower. An electric lawnmower clutch gets energy from the mower’s engine and transfers it to the mower blade.
Where is the PTO switch on a John Deere mower?
Most John Deere lawn mowers are equipped with an electric PTO (Power Take Off). The PTO is the mechanism that turns on the blades located under the mower deck. The PTO works off of a 12-volt system. The electric clutch is operated by a switch located on the dashboard of the lawn mower.
How do you adjust an electric PTO clutch?
How do you check a PTO clutch?
How do you remove an electric PTO clutch?
Why does my ride on mower cut out when I engage the blades?
1) It is not receiving enough gas or the motor isn’t warmed up enough. 2) You are not pushing in on the clutch when engaging the blades/lowering the deck or not pushing in on the clutch far enough.
How many ohms should a PTO clutch have?
Anywhere between approx. 2 ~ 4 ohms is acceptable but no way does that mean the clutch is OK. Temperature and your meter will give you varying readings. I wouldn’t replace the clutch because it has 1.8 ohms of resistance.
How long does a PTO clutch last?
LawnSite Member See people getting 600 – 1000 hours having to replace.
How do you engage PTO on a John Deere tractor?
PTO can be engaged or disengaged without operating clutch. Push down and forward on PTO switch (A or B) to engage PTO clutch. Pull back PTO switch (A or B) to disengage clutch.
What does the PTO clutch do?
Power take-off (PTO) clutches provide a mechanical disconnect between the power created by gas and diesel engines or electric motors to another piece of equipment. The PTO clutches enable the transmission of that energy to auxiliary equipment that does not generate its own power.
How do you test a John Deere PTO switch?
How do I know if my lawn mower clutch is bad?
Don’t forget to share this post 
References and Further Readings :
