Who’s never been through that? You put on the pants, skirt or dress you like best and suddenly you realize that the zipper doesn’t close. And then you spend the whole day hoping that the zipper won’t open and the opening won’t be noticed.
If you want to know how to fix zipper that keeps openingstep by step and with photos, in this article from umCOMO we explain in a quick, effective and safe way, how to fix zipper that doesn’t close so you don’t have to spend the day worrying about the state of your clothes with those tricks that can save you from a bad day. Write it down!
Table of Contents
Because the zipper doesn’t close
Sometimes, due to overuse or quality problems, zippers are the fastest breaking parts in a garment. The most delicate ones are usually plastic, common in purses and wallets, while the metal ones, placed in jackets or pants, have a longer life.
How to fix jammed zipper
A very common mistake that causes the zipper to break is to put an unsuitable size zipper on a widely used part. Zippers are not only measured by their length, but also by the size of their teeth and their strokes (slider). Some zippers simply do not have a good proportion between the teeth and the slider, which is the main reason they fail.
Zipper that does not close
The most common problems that cause a zipper to open are: slipping of the teeth, running of the cursor, which causes it to leave the zipper line, breaking of the terminal, etc. Although everything seems to indicate that the time has come to replace it, there are some tricks to fix a zipper that keeps opening.
How to fix zipper that keeps opening
Sometimes when trying to close a zipper, it keeps opening with the cursor/slider passing. This is because there are poor teeth adhesion and therefore the appropriate solution is to adjust the slider back to its place.
How to fix zipper that doesn’t close
- Take a pair of tweezers or small pliers and squeeze the base or the slider mouth;
- You should squeeze both sides of it, without putting too much pressure on it, so it won’t be totally incapacitated.
- It is advisable to apply gentle pressure and continue testing until the zipper closes completely.
Image: Pinterest.com
How to place the cursor in the zipper
When the zipper stroke has broken, this can occur for two reasons: either because the zipper has lost the terminal and the slide has left the rail, or because the zipper has lost its lower (or upper) teeth and that is why the slide has left completely.
Zipperless cursor
In both cases, the first thing to do is put the slider in its place. For this, you can make a small cut in the zipper between the upper teeth, which will allow you to open the tooth line a little. Through this opening, you can replace the slider.
If the zipper is hooked, i.e., as is the case with jackets that the slider is attached to a single line, it is not necessary to make a cut on the opposite line. If, on the other hand, the zipper is not hooked, the same cut that was made at the height of the upper teeth must be made on the other side.
Finally, these cuts must be sewn so that the slider does not return there and you can fix the zipper that keeps opening.
How to fix loose zipper (terminal)
Another reason why the zipper slider comes off is because you lost the terminal. In those cases, the best thing you can do is make a new one. In the market there are some terminals or metal parts that can be added to the foot of the zipper and are easily clampedSo, the most advisable is to bet on this option, because they are very easy to place and also very cheap.
However, you can also manufacture your own terminal. To do this, you can take a piece of thick fabric and sew it at the end of the zipper, where it has lost its terminal. If it is a small, nylon type zipper, a few stitches of thick thread will be enough to make the terminal and fix the zipper.
Image: makeitcoats.com
Fix jammed zipper
When the zipper is jammed, it’s because the slider needs lubrication. In such cases, with the help of a sharp graphite pencil, you can scratch the inside of the base of the slide, on both sides, which will be of great help to the mechanism.
If the problem is that the zipper is difficult to climb up and down, take a candle and rub it along the zipper to make it slide better. You can also bet on Vaseline, a perfect product for lubrication.
Suggestion: How to sew leather
Image: Pinterest.
Broken zipper and contingency tricks
Here are some recommendations to keep in mind if you are in a hurry and don’t really know what to do with a broken or stuck zipper:
- The paper trick: If you are on the street and suddenly notice that your zipper opened by itself when you sat down or made any movement, it happened because the leg that to the slide broke. To avoid an awkward situation, take a small piece of paper, lift the slider to the top terminal, place the paper in the slider mouth and slide it down until it stops. Problem solved.
- The ring trick: Sometimes the hook you use to lift and lower the slider breaks or comes off. When it is impossible to replace it, use the ring of your keychain and screw it into the top hole of the slide, where the buckle goes. You can also grab a clip and make a hook to lift and lower the zipper.
See also: How to sew by hand
Image: Pinterest.
If you want to read more similar articles to How to fix zipper that keeps openingWe recommend that you enter our category of Art and Crafts.
