Flame sensors and thermocouples are simple parts that wear out and fail over time, and most are easy to replace. … It is a sensitive sensor so any type of dust or carbon buildup could cause it to malfunction.
two to three years
Thereof, How do you clean a flame sensor?
Once you have removed the sensor, gently rub the metal rod (and nothing else) with a very light grit sandpaper. Remember, you’re not sanding down an auto body here, just ridding the sensor of any buildup. Then, use a clean paper towel to wipe clean any dust left behind by the sanding.
Also to know is, How much does it cost to clean a flame sensor? Generally, the cost for cleaning the flame sensor is just the service call fee, so at Cates Heating and Cooling, you are looking to pay $98. For most customers, it is easier to get started on a service plan where a Cates technician will come out to inspect and perform maintenance on your furnace annually.
Subsequently, question is, What causes a flame sensor to go bad? As with any piece of equipment a simple reason could be that dirty flame sensor just goes bad. However a more common reason is that it is just dirty. It is a sensitive sensor so any type of dust or carbon buildup could cause it to malfunction.
Also, What makes a flame sensor go bad?
As with any piece of equipment a simple reason could be that dirty flame sensor just goes bad. However a more common reason is that it is just dirty. It is a sensitive sensor so any type of dust or carbon buildup could cause it to malfunction.
How much does it cost to replace flame sensor?
Depending on which furnace repair company you call, you can expect to pay anywhere from $350 to as much as $500 for a new flame sensor, plus the cost of the travel and diagnostic charge.
How do I know if my flame sensor is bad?
Signs Your Flame Sensor May be Failing Here are three tell-tale signs that your sensor may be going bad: Your gas burners light but go out almost immediately. There is visible soot, dust, or rust that covers the tip of the flame sensor itself. The porcelain area of the sensor unit is cracked, chipped, or broken.
How much does it cost to replace a flame sensor?
Depending on which furnace repair company you call, you can expect to pay anywhere from $350 to as much as $500 for a new flame sensor, plus the cost of the travel and diagnostic charge.
How do you test a flame sensor?
How often should a flame sensor be cleaned?
Generally speaking, the flame sensor should be replaced every two to three years as preventative maintenance.
What should a flame sensor read?
When the flame lights you should read between . 5 and 10 microamps (μA) depending on the furnace. Readings between 2 and 6 are common.
How long should a flame sensor last?
two to three years
Can you bypass flame sensor?
Actually, you can bypass the flame sensor. the flame sensor is just a way of exposing the voltage on the flame sensor wire to the furnace burner flames.
What does a flame sensor do?
The flame sensor detects the presence of a flame. If the flame in the furnace goes out, the sensor can detect the change and send electrical signals to the furnace’s central controller.
How do you test a flame sensor voltage?
Why do I have to keep cleaning my flame sensor?
Could also be that your thermostat is no longer sensing the correct temperature and causing your furnace to remain on longer in the heating cycle than usual. This causes the burner to heat up the flame sensor and cause it to become dirty sooner than just a yearly maintenance.
What is the best way to clean a flame sensor?
Don’t forget to share this post 
References and Further Readings :
