A riding lawn mower that has a bad starter can be difficult to diagnose. A bad starter can manifest itself in a cranking noise without engine turnover, a clicking when the ignition button is pressed, or a mower that simply does not respond to attempts to start.
Before assuming your starter is bad, fully charge your battery and test it with a voltmeter. A charge of less than 12.4 volts means you need to buy a new battery. However, if the battery is carrying an adequate charge and the mower still isn’t firing up, your starter may be at fault.
Thereof, How do you fix a Craftsman riding lawn mower that won’t start?
Also to know is, How do I know if my lawn mower solenoid is bad? First, turn the ignition key to the “On” position. Look for the large terminal posts on the solenoid where the thick red wires connect to the solenoid. Touch the metal shaft of a screwdriver to both of the large terminals at the same time. If the engine turns over and starts, the solenoid is bad and should be replaced.
Subsequently, question is, How do you bench test a lawn mower starter?
Also, How do you test a starter motor?
How do you test a starter on a riding lawn mower?
How do you know if your starter motor needs replacing?
Again, determine if the problem is the starter or battery. If the battery is performing properly, then the starter motor is the problem. If you attempt to start the engine and it cranks slower and slower and then clicks, then the starter motor is not getting enough power to turn over the engine.
Will a bad solenoid drain battery on lawn mower?
There’s pretty much no way for a solenoid to drain the battery. All it does is make connection from the battery cable to the starter cable. You might just have a bad battery. Lawn mower batteries seldom last much more than 2 years.
How do I know if my riding lawn mower solenoid is bad?
First, turn the ignition key to the “On” position. Look for the large terminal posts on the solenoid where the thick red wires connect to the solenoid. Touch the metal shaft of a screwdriver to both of the large terminals at the same time. If the engine turns over and starts, the solenoid is bad and should be replaced.
How do you bypass a starter solenoid on a lawn mower?
What does a lawn mower solenoid do?
The starter solenoid on a riding lawn mower is essentially an electromagnetic switch. This switch closes when you turn the ignition key, allowing electricity to flow to the starter.
What are the symptoms of a bad starter solenoid?
– Nothing happens. …
– A single “click” sound comes from the engine compartment or from under the car. …
– Repeated “clicking” sounds usually indicate a dead battery.
How do you test a starter on a car?
How do you fix a riding lawn mower that won’t start?
Replace the riding mower ignition coil The ignition coil in a riding mower or lawn tractor produces the energy to cause the spark at the spark plug. The ignition coil is the likely the cause when the engine won’t spark if, after you remove the kill wire, there’s no spark from a known good spark plug.
How can you tell if your starter motor is going?
– Something sounds off. One of the symptoms of a bad starter is a clicking noise when you turn the key or push the start button. …
– You’ve got lights but no action. …
– Your engine won’t crank. …
– Smoke is coming from your car. …
– Oil has soaked the starter.
What keeps draining my lawn mower battery?
One issue is loose cables where they connect to the battery posts. A loose connection makes a battery work harder, thereby draining it of power more quickly. Cleaning the posts and tightening the connections should renew the battery’s ability to hold a charge. A larger problem is a cracked battery case.
What are the symptoms of a bad starter on a car?
– Something sounds off. One of the symptoms of a bad starter is a clicking noise when you turn the key or push the start button. …
– You’ve got lights but no action. …
– Your engine won’t crank. …
– Smoke is coming from your car. …
– Oil has soaked the starter.
Don’t forget to share this post 
References and Further Readings :
