Main Simon XT panel – Arming: o Use the DOORS + WINDOWS button to arm all the doors, windows, glass breaks, etc. o Use the MOTIONS button to arm any motions detectors you might have. o Press one after the other to arm Doors + Windows and Motions. o Press DOORS + WINDOWS 2 times to arm doors + windows with no entry …
Thereof, How do I turn off Simon XT alarm?
Press either button until you locate “Panel Piezo Alarm”, press the “OK” button. The “On” or “Off” selection should begin flashing. This will indicate that the option can be changed. Press the up or down arrow to set the option to “Off”.
Also to know is, How do you put Simon XT in test mode?
Subsequently, question is, How do you take the battery out of a Simon XT?
Also, How do I change the battery in my Simon XT sensor?
How do I change the battery in my motion sensor alarm?
To change the battery, first remove the screw in the motion detector. The screw may be located on the top or bottom. Use a flathead screwdriver to press the tab on the bottom of the motion detector.
How do I turn off my Simon XT alarm?
– 2) Go to your keypad and press down on the two tabs on the top of the keypad. This will allow for the front of the keypad to swing down.
– 2) Disconnect the battery from the panel by taking off the positive and negative leads from the battery.
– ***!!! ***you have just powered down your Simon XT Panel***!!! ***
How do you bypass the sensor on a Simon XT?
– Press Doors+Windows then Motions to Arm.
– Press Bypass then enter Master Code then press or to scroll sensors.
– Press OK or BYPASS to bypass and Arm.
How do you disarm Simon XT without code?
Keyfob- Arming: o Press the LOCK button once to arm Doors + Windows. o Press the LOCK button twice for Doors + Windows and Motions Disarming: o Press the UNLOCK button once to disarm the system.
How do you change the battery in a Simon XT Motion Sensor?
– Press top button then remove sensor from backplate.
– Hold top and bottom tabs then pull motion from front cover.
– Remove and replace AA Alkaline batteries then replace motion on backplate.
How do I get my Simon XT to stop beeping?
o There may be a trouble condition (low battery, failure, etc). You can check this on your main panel by pressing the STATUS button. 1. To stop the touch screen from beeping, go into the SETTINGS menu and turn the VOLUME all the way down.
How do I reset my Simon XT alarm?
You can reset an Interlogix Simon XT to factory defaults by first powering down the panel completely. Then hold down the four top buttons on the panel while the system is being powered back on. If successful, the Simon XT will reboot with its factory default settings fully restored.
How do I change the battery in my glass break sensor?
How do you bypass a sensor?
– Press the Bypass button and enter your Master Code.
– Use the arrow buttons to scroll to the sensor you wished to bypass. On the first line, the display will show the sensor number and name (ex: SN 1 Front Door).
– Press “OK” to bypass (deactivate) the sensor.
How do you reset a glass break sensor?
For some sensors, it’s necessary to press the button on the glass break sensor a set number of times, pause, then press it again. That resets the sensor and allows it to continue working normally.
How do you open a GE Simon XT?
How do I reset my Simon XT security system?
You can reset an Interlogix Simon XT to factory defaults by first powering down the panel completely. Then hold down the four top buttons on the panel while the system is being powered back on. If successful, the Simon XT will reboot with its factory default settings fully restored.
Don’t forget to share this post 
References and Further Readings :
