In general the trolling plates of most brands — will slow down the boat by about 2/3’s. i.e. if you can troll at three miles, per hour – you will slow down to about 1 mph. Remember – however — that if you intend to backtroll — it is not in your best interest to use a trolling plate.
On Plane Control – In the up position, a trolling plate with fins acts a hydrofoil, allowing your boat to remain on plane at slower speeds. It can also reduce the amount the bow slaps up and down on the water at lower speeds, also known as the porpoising effect.
Thereof, How do I slow my boat down for trolling?
Shut Down Your Boat’s Engine(s) With triple outboards, for example, shutting down the center engine (or leaving it in neutral) will help you troll slower. If that’s not slow enough, use just the center outboard and turn off the two outside motors. With quad outboards, try running just two motors.
Also to know is, How can I reduce my troll speed? – Shut Down Your Boat’s Engine(s) If your boat has multiple outboards, shutting down one or more engines will allow you to drop speed. …
– Shifting Engines Out of Gear. …
– Using Drift Socks and Trolling Bags. …
– Benefits of an Auxiliary Outboard Engine. …
– Using an Electric Motor. …
– Outboard Engines with Troll Mode.
Subsequently, question is, What size drift sock do I need for trolling? Sideways Drift Using two drift socks are preferred. One will attach near the bow and the other at the stern. For the bow use the smaller 33-inch drift sock is recommended. Likewise for the stern, you can either use a 30-inch drift sock (for a smaller boat) or a larger 50+ inch drift sock for larger/heavier boats.
Also, Can you troll with a 25 hp motor?
I troll with 4stroke 70hp and it works just fine. If the 25 is to fast throw 1 or 2 sea anchors out. … If they don’t you can always add a flip down trolling plate. That stops enough water from the prop to really slow you down.
What size trolling bag do I need?
The size of the bag needed is dependent largely upon the size of the boat, the speed of the boat with no bags out, and how slow you need your boat to go. The following measurements are just a guideline. The 15″ and 18″ bags are used on 12′ to 20′ boats. The 22″ bag is used on boats from 20′ to 24′.
How do you use a 5 gallon bucket for drift socks?
– Flip a 5-gallon bucket upside down on a steady even surface.
– Drill into the bottom of the bucket with a 1/2 inch drill bit fitted on a power drill. …
– Tie the end of a 10-foot nylon rope to the handle of the bucket.
– Tie the other end of the bucket to the bow of your boat.
How do you make a homemade drift sock?
How do you use trolling drift socks?
Is trolling bad for outboard?
You use a four-stroke outboard, either your primary motor or a kicker, for trolling. … “But even if the motor doesn’t fail, oil contaminated with fuel could cause accelerated wear on many components in the motor.”Mar 22, 2007
How do you use a trolling plate?
Pull the cord and the plate will move into the down trolling position. The plate will lock into place when properly seated, slowing the boat’s trolling speed. When you are ready to move at speed, release the EasyTroller plate by pulling on the cord with the motor idling and in forward gear.
Can you troll with a 90hp motor?
Any motor can be used for trolling, if the prop pitch is correct. If you want to use your 90 hp motor for trolling, install a 12 or 13 pitch prop – as opposed to a normal 15 or 17 pitch prop.
How do I slow my outboard for trolling?
Shut Down Your Boat’s Engine(s) With triple outboards, for example, shutting down the center engine (or leaving it in neutral) will help you troll slower. If that’s not slow enough, use just the center outboard and turn off the two outside motors. With quad outboards, try running just two motors.
What is a good speed for trolling?
between 1.5 and 2.5 mph
What size drift sock should I get?
When purchasing a drift sock, the rule of thumb is to buy one to match the length of boat you run. This will give you a ballpark size to begin your search with, which can then be fine-tuned to the perfect fit dependent on what severity of wind conditions you routinely face.
How fast can a 25 hp motor go?
Normal amount of gear waves and 2 regular size dudes it goes about 20 consistently. Adding a 3rd person is a real speed killer and we can crawl down to 15 mph. 25 mph sounds about right, which is going at a decent clip.
How does a drift sock work?
A drift sock is a large “bag” (think parachute) that attaches to the boat with a harness and a buoy. … The action of the drift sock dragging in the water helps to keep the boat straight or moving in the intended direction and also helps to slow the boat down as it’s drifting across the water.
Don’t forget to share this post 💖
References and Further Readings :