unbalanced load
Thereof, Why does my Maytag washer leak from the bottom?
The drain pump pumps water out the drain hose. If the drain pump is cracked or damaged, or if the bearings are worn out, the drain pump may leak water. … The tub seal might be torn, causing water to leak from the seal. If the tub seal is leaking water, water may leak through the tub seal and into the tub bearings.
Also to know is, Why would a washing machine leak from the bottom? Leaks under the washer are commonly caused by a damaged water pump or compromised hoses connected to the pump. Usually, you will notice lots of rumbling or shaking from the machine during a wash cycle if the pump is faulty. The water pump in a washer is generally located at the bottom of the machine.
Subsequently, question is, How do I reset my Maytag washer? – Unplug the washer for 1 minute from the electrical outlet.
– Plug the washer back in and lift and lower the lid 6 times within a 12 second period. You have 30 seconds to start lifting and lowering the lid.
– The motor has now been reset and is ready for you to start a cycle.
Also, How do you run a diagnostic test on a Maytag washer?
Now you can do run a Maytag Centennial automatic diagnostic washer cycle. You will need to start the diagnostics mode again, but this time turn the Centennial washer’s cycle knob right until only the “spin” light is lit and press “start”. The washer will do a quick cycle that will test all the washer functions.
How do you replace the seal on a Maytag washer?
How do I fix error code UL?
How do you fix the UL code on a Maytag washer?
Can I replace the seal on my washing machine?
If your door seal has blackened beyond what cleaning can fix or is old and damaged, it can be replaced. Start this repair by unplugging your washer and disconnecting it from the water. … Before installing the new seal, clean the area underneath the old seal thoroughly and let dry.
How do I reset my Maytag top load washer?
– Unplug the washer for 1 minute from the electrical outlet.
– Plug the washer back in and lift and lower the lid 6 times within a 12 second period. You have 30 seconds to start lifting and lowering the lid.
– The motor has now been reset and is ready for you to start a cycle.
Why does my Maytag washer not start?
If the washer overheats, the thermal fuse will blow. If the line fuse blows, the washer won’t start. To determine if the thermal fuse is at fault, use a multimeter to test it for continuity. If the fuse does not have continuity, replace it.
How do I fix a leaking washing machine?
– Locate the Source of the Leak. Empty the washing machine, move it away from the wall and start the fill cycle. …
– Look Inside the Machine. …
– Replace a Leaky Pump. …
– Loosen the Bolts. …
– Remove the Old Pump. …
– Retighten the Bolts. …
– Lift the Lid. …
– Remove the Agitator.
Why is my Maytag washer not turning on?
Check to see if a household circuit breaker or Ground Fault Circuit Interrupter (GFCI) outlet has tripped. If so, reset the circuit breaker or Ground Fault Circuit Interrupter. If the washer is on a fuse box, check to see if a fuse has blown and replace it, if necessary.
Is there a reset button on a Maytag washer?
Is there a reset button on a Maytag washer? … Plug the washer back in and lift and lower the lid 6 times within a 12 second period. You have 30 seconds to start lifting and lowering the lid.
How do you fix a washing machine door seal?
How do you reset a washing machine?
Turn the machine off at the powerpoint, wait for one minute, and then turn it back on. If you see no change, you can try a Master Reset. This will reset all of the onboard componentry and is often successfully used by appliance technicians. Open and close the door of the washing machine 6 times within 12 seconds.
How do you clean the rubber seal on a washing machine?
Clean Gasket: Use a rag or towel to clean the rubber door gasket on a front-loading washer with either hot soapy water or a spritz of mildew cleaner. Make sure to wipe underneath and around it as well. Be prepared for some slime and gunk, and possibly a stray sock or two!
Don’t forget to share this post 
References and Further Readings :
