Turn the light switch on and off rapidly approximately four times. The light will eventually stay on continuously. Once the light is on, turn the switch off, wait five seconds and turn it back on again. The light should stay off and the sensor should be reset.
The manufacturers have made it a simple process. Locate the switch that controls the motion sensor light, then flip it off and on quickly. This rapid flip of the switch tells the light to put the motion back in its function.
Thereof, How do you trick a motion sensor light to stay off?
Often, the wind blowing through leaves and branches can cause the motion sensor to detect motion, causing the light to stay on. Turn off the switch which operates the motion sensor light. Keep the switch off for 1 to 2 seconds and then turn the light switch on again.
Also to know is, What can set off a motion detector? A motion detector sees movement, but it relies on what that movement is doing. Namely, changing light or shadow levels as they go by. Because the sensors rely on these movements, it’s possible that the way a tree is blowing in the wind and casting patterns on the carpet can be enough to set off a motion detector.
Subsequently, question is, How do you adjust a sensor light switch?
Also, How do I reset my Lutron sensor?
Can a mouse set off a motion detector?
Homeowners with pets should be certain the home security system has sensors that are “pet- friendly,” as pets that are free to roam the house will trigger motion detectors and activate a false alarm. Rodents and insects can also trigger alarms.
What can cause a motion sensor to false alarm?
– Flying or crawling insects; spiders like to make homes in corners and anchor their webs to the sensors.
– Pets.
– Curtains or plants blown by air conditioning or heaters.
– Low batteries.
– Ceiling fans.
– Objects moving near motion sensors.
How do I reset my Lutron?
How do I factory reset my Lutron Caseta switch? Rapidly tap the top “on” button three times and on the third tap hold until the lights connected to the switch begin to dim up and down, immediately tap the top “on” button three times rapidly. The connected lights will then alternate dim and bright slowly.
What is the best motion sensor light switch?
– Lutron Maestro Sensor Light Switch MS-OPS2. …
– Leviton Decora OSSMD-GDW. …
– Enerlites MWOS-W Motion Sensor Switch. …
– Jasco GE Z-Wave Plus Smart Lighting Control Motion Sensor Switch. …
– ecobee Switch+ Smart Light Switch.
Why is my motion sensor light not working?
If the light won’t come on after adjusting and cleaning the sensor, try a simple trick. … If that doesn’t work, the sensor may be bad. To find out, turn off the breaker again and disconnect the wires connecting the sensor to the light fixture. Connect the light directly to the circuit wires and turn on the breaker.
How do you sync a Lutron light switch?
How do you wire a Lutron fan and light switch?
How do you turn off a motion sensor light switch?
Most manufacturers make it a fairly easy process to disable this main feature of the lights. A switch on the fixture should read “on time,” usually found directly under the motion sensor. Set it to any position, aside from the test position, and flip off the switch that the light is connected to.
Why does my sensor light not turn off?
If your outdoor security light won’t turn off, it’s most likely because of one of these problems: The sensitivity settings are too high. The duration settings are too high. It’s stuck in auto mode.
Can a bug set off a motion detector?
Insects and small animals set off PIR motion detectors because they emit the infrared (IR) energy needed to activate the devices. If an insect or small animal gets close enough to the sensor, then they will be able to activate it. Some motions have bug guards to prevent this from happening.
How do you test a motion sensor light?
How do you program a Caseta switch?
Don’t forget to share this post 
References and Further Readings :
